Application Examples; Dual Mode, Low Z (8Ω, 4Ω, Or 2Ω) - Crown 2/300 Operation Manual

Application Examples

Dual Mode, Low Z (8Ω, 4Ω, or 2Ω)
Audio Architect software settings are shown in
output wiring is shown in
Figure 59
INPUTS: Connect the input wires for each channel. See
for further information on analog input
Connectors" on page 7
wiring.
If the same input signal is to drive multiple outputs, the input signal
can be "Y'ed" by checking the "Y" checkboxes (see
"Configuring Amp Wiring & Bridge Mode" on page 13
more information.
If using the BLU link input, it is important to understand that BLU link
is a digital audio bus and cannot be routed through an Ethernet switch
or router. Category 5e or higher cabling must be used for all BLU link
connections. To use the built-in BLU link fault protection, the BLU
link output of the last device on the bus must be connected back to the BLU link input of the first device. For additional information on making BLU link
connections and using BLU link, see
OUTPUTS: Maintain proper polarity (+/–) on output connectors. Connect the Channel 1 speaker's positive (+) lead to amplifier Channel 1 positive
terminal; repeat for the negative (–) lead. Repeat Channel 2 wiring as for Channel 1, and for any subsequent channel pairs on multichannel models. See
"Wiring Output Connectors" on page 7
NOTE: Always route the input and output wires in separate bundles.
WARNING: Only connect to networks that remain inside the building.
CDi DriveCore Series Operation Manual
. Typical input/
Figure 58
.
"Wiring Input
). See
Figure 58
for
"Using BLU link" on page 49
for additional information on output wiring.
Figure 59:
Application Examples
Figure 58:
.
2 1 2 1
2 1
System wiring in Dual mode
Audio Architect amplifier mode settings
Page 45