Download Print this page

Midea SB 80-9373 User Manual page 14

24 inch ada standard build in dishwasher

Advertisement

Before you call for service
Problem
Possible Causes
Spots and filming
Extremely hard water
on glasses and
Low inlet water temperature
flatware
Overloading the dishwasher
Improper loading
Old or damp powder detergent
Rinse agent dispenser empty
Too little detergent
Cloudiness on
Combination of soft water and
glassware
too much detergent
Water temperature entering
the dishwasher exceeds 150°F
Black or gray
Aluminum utensils have
marks on dishes
rubbed against dishes
Yellow or brown film
Tea or coffee stains
on inside surfaces
An overall yellow or brown film can
be caused by iron deposits in water
White film on inside Hard water minerals
surfaces
'
Dishes don t dry
Low inlet water temperature
Rinse agent dispenser is empty
Dishwasher won t '
Fuse is blown, or the
run
circuit breaker tripped
Steam
This is normal
What To Do
UseJet-Dry rinse agent to remove spots and prevent new film buildup.
T o remove stubborn spots and pre-existing film from glassware:
1 Remove all metal utensils from the dishwasher.
2 Do not add detergent.
3 Start the dishwasher and allow to run for 30 minutes. Dishwasher
will now be in the main wash.
4 Open the door and pour 2 cups (500 ml) of white vinegar into the
bottom of the dishwasher.
5 Close the door and allow to complete the cycle. If vinegar rinse does not
work: Repeat as above, Except use 1/4 cup (60 ml) of citric acid crystals
instead of vinegar.
This is called Etching and is permanent. T o prevent this from happening,
Use less detergent if you have soft water. Wash glassware in the shortest
cycle that will get them clean.
Lower the water heater temperature.
Remove marks with a mild, abrasive cleaner.
Remove the stain by hand, using a solution of 1/2 cup bleach and
3 cups warm water.
CAUTION
Before cleaning interior wait at least 20 minutes after a cycle for the
temperature to cool down. Failure to do can result in scalding.
A special filter in the water supply line is the only way to correct
this problem. Contact a water softener company.
T o clean the interior, apply dishwasher detergent to a damp sponge.
Wear rubber gloves. Do not use any type of cleanser other than
dishwasher detergent because it may cause foaming or sudsing. Cascade
Cascade CompleteAnd Electrasol Automatic Dishwashing Detergents
have been approved for use in your dishwasher.
Make sure inlet water temperature is correct (see page 4 ).
Check the rinse agent dispenser.
Replace fuse or reset circuit breaker. Remove any other appliances
from the circuit.
Steam comes through the vent during washing, drying and when
water is being pumped out.
12

Advertisement

loading