Troubleshooting - cectek Kingcobra Manual

TROUBLESHOOTING

This section is provided to help in diagnosing the problem of some common complaints
Improper repairs of adjustment may damage the vehicle instead of
fixing it. Such damage may not be covered under warranty.
If you not sure about the how to repair your vehicle, consult your
CECTEK dealer about the problem.
SYMPTOM
POSSIBLE REASON
1. Main switch is in "OFF".
2. Transmission is not in "N"
position.
3. Engine Stop Switch is in
"STOP" position
4. Burnt fuse
5. Weak battery or loose
connection.
SYMPTOM
POSSIBLE REASON
1.Burnt Fuse
2. Fuel level too low
3. Failed Spark Plug
SYMPTOM
POSSIBLE REASON
1. Fouled or damaged spark
plug..
2. Fuel level too low
3.Engineoverheat
4. Air filter/ box plugged or
dirty
5.CVTdirtyorwear
CAUTION
Press "Start", but engine does not run
TROUBLE SHOOT
Turn the key to "ON" position.
Turn the gear selection knob to "N" position.
Switch the "Engine Stop Switch" to "RUN" position.
Check Fuses
Check battery voltage, Check connection and check,
Charge the battery, Check charging voltage after starting.
Engine rotates, but fails to start
TROUBLE SHOOT
Check Fuses
Check fuel level in the fuel tank
Remove spark plug then reconnect to ignition coil, Start the
engine with spark plug grounded to engine but not in the
hole of spark plug. If no spark, replace a new spark plug. If
the trouble persists, contact CECTEK dealer.
Enginelacksaccelerationorpower
TROUBLE SHOOT
Refer to "Engine rotates, but fails to start" section.
Refer to "Engine rotates, but fails to start" section.
Contact your CECTEK dealer for checking the coolant
system or possible reasons.
Checktheairintake.
Check the air filter and clean it.
Check deposits in the air box drain.
Contact your CECTEK dealer.
115