Table of Contents
Advertisement
SmartWatch® Network Video Recorder User Manual
the HiDDNS server you created.
User Name: Enter the user name of the device. By default it is admin.
Password: Enter the password of the device. By default it is 12345.
5. Click Apply button to save and exit the screen.
9.2.3 Configuring NTP Server
A Network Time Protocol (NTP) Server can be configured on your NVR to ensure the accuracy of system
date/time.
Steps:
1. Enter the Network Settings screen.
Menu >Configuration> Network
2. Select the NTP tab to enter the NTP Settings screen, as shown in Figure 9. 12.
3. Check the Enable NTP checkbox to enable this feature.
4. Configure the following NTP settings:
•
Interval: Time interval between the two synchronizing actions with NTP server. The unit is minute.
•
NTP Server: IP address of NTP server.
•
NTP Port: Port of NTP server.
5. Click Apply button to save and exit the screen.
The time synchronization interval can be set from1 to 10080min, and the default value is 60min. If the
NVR is connected to a public network, you should use a NTP server that has a time synchronization
function, such as the server at the National Time Center (IP Address: 210.72.145.44). If the NVR is setup
Figure 9. 11 Access Device via SMM
Figure 9. 12 NTP Settings Screen
115
Advertisement
Table of Contents
