To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +561.391.7200
HOW TO: ALIGN MOUTH MOTOR & SENSOR
This black plastic blocks sensor to position mouth. (Open
HOW TO: CHANGE SENSOR
1.) Remove 2 sets of
nuts and bolts
Motor will go forward and backward to open and close mouth.
Encoder Wheel (Part # AACA3258)
or Closed)
The mouth is closing when sensor is being blocked.
The mouth is opening when sensor is clear.
Top of wheel rotates toward back of game and down.
Important that "Motor Side" is installed toward motor.
2.) Remove 4 screws in
motor mounting plate.
Notch Sensor (Part # AACB4401)
This sensor "sees" the notches of the notch wheel.
Game keeps track of mouth position with this sensor.
3.3 Volts DC normally between black and white wires.
Drops to 0 Volts DC when notch is blocking sensor.
Mouth Motor (Part # AAMO4101)
12 Volt DC motor.
5-6 Ohms
3.) Remove motor assy
from game.
26
4.) Remove set
screw in hub.
4.) Replace faulty sensor
and re-assemble parts.