Error Codes - Bay Tek Games Arctic Chomp Service Manual

To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +561.391.7200
There will be a dot on the display board during game play.

In the menu, select "N11 - Diagnostics" to show error codes

L will show when switch
is held down by tickets.
L If L is not showing:
Ticket tray empty.
Faulty low ticket switch.
Broken/loose wires.
Ball scoring sensor is
blocked.
1
Motor sensor is
blocked.
2
Coin switch is held
down or stuck.
o
No switches stuck.
-

ERROR CODES

There are a few ways the game will show an error.
At power ON, the game will display error codes.

When tickets are in game, L should show in the diagnostic N11.
Load tickets.
Make sure ticket stack rests on top of wire actuator of switch.
Replace switch. (AASW200)
Check cable connections from switch to main circuit board.
(AACE3219, AACE3206)
Refer to "How to Access Ball Count Sensor". Clean sensor and
check for broken balls.
Check cable from sensor to main board. (AACE3200)
Replace sensor. (AABD4012)
Refer to "Mouth Motor and Sensor Alignment".
2 should only show in diagnostics when wheel encoder is
blocking sensor.
Clean sensor. (AABD4012)
Check cable from sensor to main board. (AACE3200)
Replace sensor. (AABD4012)
Unplug one coin switch at a time and verify coin switch is
wired normally open. 5 Volts between white and black wires.
Check connectors and continuity on wires.
(AACE3202, AACBL4A-DOOR)
Replace coin switch if needed. (A5SW4000)
No switches blocked or stuck. All switches open.
22