Windows Nt Environment - Acard AEC-6880 User Manual

ACARD AEC-6880

4.1.3 Windows NT Environment

Driver installation is required when it is the first time to setup Windows NT
into the System
For Boot Device
AEC6880.SYS is designed for Microsoft Windows NT miniport drivers. It
allows driver connects to IDE devices (which support by Microsoft)
1. Insert Windows NT boot disk and boot from floppy disk.
(If boot from CD-ROM or install from hard disk, please press
"F6" for the first booting screen)
2. Follow the Windows NT setup procedures.
3. Press "S" to skip mass storage devices detection.
4. Move the highlight bar to "the other" and press "Enter".
5. Before the installation, copy the AEC-6880's driver into a floppy diskette
first. Then insert the ACARD AEC-6880 driver disk into the floppy.
6. The ACARD Miniport driver should be highlighted at this stage. Press
"Enter" to proceed.
7. NT should now recognize the ACARD Miniport driver and the IDE
hardware. Please follow the Microsoft Windows NT installation.
Install Driver for Windows NT
After Windows NT has been installed, you may wish to plug the ACARD
AEC-6880 device on the Windows NT system. Follow the procedures below,
Windows NT would install the newest ACARD AEC-6880 driver to the
system.
20