Washer Maintenance - Kenmore 11026002011 Use And Care Manual

8. Select cycle settings
I Hot
E× Heavy
Warm
Cool _1
Cored
High
Low
No Spin
ADJUSTS WASH TIME
Once you select a cycle, the default settings for that cycle will
be lit. Press the cycle modifiers buttons to change the Wash Temp,
Soil Level, and Spin Speed, if desired.
NOTE: Always read and follow fabric care labels instructions to
avoid damage to your garments.
Hot
Some cold water is added to save
energy. This may be cooler than
your hot water heater setting.
Warm
Some cold water may be added,
so this will be cooler than what
your previous washer provided.
Whites and pastels
Durable garments
Heavy soils
;;i Bright colors
;;i Moderate to light soils
Warm water is added to assist _iColors that bleed or fade
in soil removal and to help Light soils
dissolve detergents.
Cold
Warm water may be added to Dark colors that bleed
assist in soil removal and to help or fade
dissolve detergents. Light soils
9. Select cycle options
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as 2nd Rinse. These can be turned off, if desired.
NOTE: Not all options are available with all cycles.
lOe Select Start/Pause/Unlock Lid
to begin wash cycle
@
START/PAoUS E
Press the START/PAUSE/UNLOCK LID button to start the wash
cycle. When the cycle has finished, the CYCLE COMPLETE
indicator will light up. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of metal
hooks, zippers, and snaps.
Unlocklng the lld to add garments:
If you need to open the lid to add 1 or 2 missed garments, you
may do so during the first portion of the Sensing step. Press
START/PAUSE/UNLOCK LID; the lid will unlock once the washer
movement has stopped. This may take several minutes if the load
was spinning at high speed. Then close lid and press START/
PAUSE/UNLOCK LiD again to restart the cycle. If lid is left open
for more than 10 minutes the water wnJ pump out.
WASHER MAINTENANCE
f WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
CLEANING YOUR DISPENSER TRAY
You may find laundry product residue leftover in your dispenser
trays. To remove residue, follow this recommended cleaning
procedure:
1. Pull tray out until you feel resistance.
2. Lift up slightly, and then continue pulling out.
3. Wash in warm, soapy water, using a mild detergent.
4. Rinse with warm water.
5. Air dry, or dry with a towel, then place back into slot.
iMPORTANT: Dispenser trays are not dishwasher safe.