Table of Contents
Advertisement
No label size
Table 7 Error Messages and Fault Corrections Part 1
Error message
Head open
Head too hot
Read error
Cutter jammed
Card full
Cutter blocked
Out of paper
Protocol error
Buffer overflow
Write error
Write protected
Font not found
Invalid setup
Voltage error
Memory overflow
Structural error
Unknown card
USB error
Device stalled
USB error
Too much current
USB error
Unknown device
Table 7 Error Messages and Fault Corrections Part 2
Users Manual for T4000+ Series
Timeserver, or the Timeserver is
currently available
The size of the label is not defined
in the programming.
Cause
Print head not locked
Print head is overheated
Read error when reading from the
memory card
The cutter is unable to cut the
labels but is able to return into its
home position
No more data can be stored on
the memory card.
Cutter cannot return into its home
position and stays in an undefined
position
No cutter function
Out of label roll
Error in the paper feed
Printer has received an unknown
or invalid command from the
computer.
The input buffer memory is full
and the computer is still
transmitting data.
Hardware error
PC card write protection is
activated.
Error with the selected download
font.
Error in the configuration memory
Hardware error
Current print job contains too
much information, e.g. selected
font, large graphics
Error in the file list of the memory
card, data access is uncertain.
Card not formatted. Type of card
not supported.
A USB device has been detected,
but it is not working
The USB device consumes too
much current
Failure to detect USB device
network administrator.
Check programming.
Comment
Lock print head.
After pausing the print job will
be continued automatically. If
the fault recurs repeatedly,
reduce the heat level or the
print speed via software.
Check data of the card.
Backup data, reformat card.
Press the cancel key. Change
material.
Replace card.
Switch off the printer. Remove
material. Switch on the printer.
Restart print job. Change
material.
Switch the printer off and then
on. If error recurs call service.
Load labels.
Check paper feed.
Press the pause key to skip the
command or press the cancel
key to cancel the print job.
Use data transmission via
protocol (preferably RTS/CTS).
Repeat the write process,
reformat card.
Deactivate the write protection.
Cancel current print job,
change font.
Re-configure printer. If error
recurs call service.
Switch the printer off and then
on. If error recurs call service.
It is shown which voltage has
failed. Pleae note
Cancel current print job.
Reduce amount of data to be
printed.
Format memory card.
Format card, use different type
of card.
Do not use the USB device.
Do not use the USB device.
Do not use the USB device .
27
Advertisement
Table of Contents
