Advertisement
System Installation and Wiring
Camera System installation on diesel vehicles may require a slightly different wiring install. These installation instructions do not apply
to all types of vehicles. They are meant only as a general guide due to the large number of vehicle makes and models. Consult your
local motor vehicle laws on the use of this product to be sure it is permitted. Through installation of this backup camera system, you
should be sure as to not degrade, damage or compromise the safety of any system or device on your vehicle. Improper installation
and wiring of the vehicle back-up camera system may damage the vehicle's electrical system, including vital vehicle computer and
operating systems. That could lead to an accident or fire, causing property damage and /or serious personal injury. It is highly
recommended to seek professional installation advice from a qualified auto electrician or, in the alternative, to have the installation
performed by a qualified auto electrician.
Please ensure that your monitor is secured and mounted where it would NOT obstruct any OEM vehicle safety features. In an event of
an accident, manufacturer is not responsible for bodily injury caused by the monitor being a projectile. Select location for mounting
the monitor in desired location. Ensure monitor location will not obstruct your vision while driving. The manufacturer assumes no
liability for damage caused to your vehicle due to improper installation or use.
Caution: This unit is designed to operate on a 12V/24V DC NEGATIVE GROUND electrical systems. Connecting to other types of electrical
systems will cause damage to your vehicle. Please contact the manufacturer if you are unaware of the system type in your vehicle.
Quick Installation:
The backup camera system is compatible with a wide range of vehicles and video display monitors.
This kit includes necessary wiring and cable connector accessories sufficient for typical connections. However,
additional accessory cables and installation materials may be necessary for a completely secure and
operational backup camera performance system.
Connect the camera, using the red cable, of the DC 12V power cable, to the positive 12V reverse tail light in the
rear of your car. You may need to temporarily remove an interior panel or other cover. Then, connect the black
wire, of the DC 12V power cable, and ground properly. This connected power and ground cable connects to the
camera, and will supply power to the camera directly. (Red wire is positive, black wire is negative)
Then use the included yellow RCA video connector cable, and run that cable to the yellow RCA video connector
jack of the camera, to the RCA video connector of a compatible video display monitor.
*The system includes an additional video input connection, so you will have the ability to connect an additional
video input source. The input source is then selectable via button on the mirror monitor assembly. (V1/V2)
Connect the monitor using the included power and video wiring harness. Using the red cable, of the power and
video wiring harness, connect to your vehicle's fuse panel
be powered when your vehicle is on, or activated by key. Then connect the black wire, of the DC 12V input, and
ground properly. The green wire, on the power and video wiring harness, is the 12V reverse gear positive
trigger, which will provide a picture, to the mirror video monitor assembly, when the gear is placed in reverse.
The power and video wiring harness then connects to the mirror video monitor assembly. This connection will
supply power to the monitor directly.
*Refer to the installation / wiring diagram in the manual
(preferably to the 12V ignition switch)
- which will only
Advertisement
