Setting The Clock - Audiovox Rampage ACD-25 Owner's Manual And Installation Manual

NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-side-up when
attaching it to the chassis as it cannot be attached
when up-side down.
2. Do not press very hard on the front panel when
attaching it to the chassis. No more than light to
moderate pressure should be needed.
3. When attaching the front panel, make sure the
right side is correctly engaged before pressing the
left side to lock it into position.
4. When taking the front panel with you, please use
the supplied carrying case to protect the panel from
dirt and damage. Make sure there is no dust or
dirt on the electrical terminals on the back of the
panel as this could cause intermittent operation
or other malfunctions.
1. Turn the vehicle ignition and radio "on".
2. Press and hold the Time/Frequency Selector button
begins flashing on the display panel.
3. Within 5 seconds after the time display begins flashing, press the Manual Down Tuning button (
adjust the hours and the Manual Up Tuning button (
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and normal
operation can resume.
9 9 9 9 9

SETTING THE CLOCK

SETTING THE CLOCK
SETTING THE CLOCK SETTING THE CLOCK SETTING THE CLOCK
cp
) to adjust the minutes to the correct time.
DETACHING THE FRONT PANEL
Release Button
ATTACHING THE FRONT PANEL
approximately 2 seconds until the time display
Engage right
side first
) to