Alcatel MDR-8000 User Manual page 65

MODULE/UNIT
AE-27AF Relay Interface
AE-37Y Controller
CE-16BB Power Supply
Fuse
DX-35M DS1/E1 I/O Interface
DX-35N DS3 I/O Interface
DX-35P OC3 I/O Interface
UD-35( ) Transmitter
Crystal Oscillator Subboard
Capacity Key
UD-36( ) Receiver
Crystal Oscillator Subboard
Capacity Key
UD-51( ) Power Amplifier
LBO/AUX Interface
RF Switch
(1)
If ATPC is in use, it must be provisioned disabled or locked high before removing controller.
(2)
Appendix E is on attached CD.
Table 5-2 Module Replacement Matrix
REMOVAL/REPLACEMENT
PROCEDURE
No Special Procedure Required
Chart 2
Chart 1
No Special Procedure Required.
Refer to Operations Section for
Location.
Chart 3
Chart 3
Chart 3
Chart 4
Figure 5-17
Figure 5-18
Chart 5
Figure 5-19
Figure 5-20
Chart 6
Chart 7 in the Maintenance sec-
tion on the attached CD
Chart 8 in the Maintenance sec-
tion on the attached CD
CHECKS/ADJUSTMENTS
PROCEDURE
None Required
None Required
None Required
None Required
Appendix E
None Required
Appendix E
The crystal oscillator subboard
and crystal part numbers define
this unit. The crystal is soldered
to the oscillator subboard and
factory tuned to the customers
requirements.
Appendix E
The crystal oscillator subboard
and crystal part numbers define
this unit. The crystal is soldered
to the oscillator subboard and
factory tuned to the customers
requirements.
Appendix E
No Special Procedure Required
No Special Procedure Required
5-21