Alcatel MDR-8000 User Manual page 42

Remote Time-Out Constants -- MDR-8000
Select a value in the following list to change the current remote timeout
Alcatel User Interface - [Alarm Status -- MDR-8000 OC3]
File View Setup Options
F3 F4
✓
Acknowledge Alarm Status
ELMC Address [F8]: J7914
ELMC Description: DURANGO
TRANSMIT
A
STATUS
TRANSMITTER
If the time-out value selected is too short, there
may not be enough time for the remote
controller to respond before the requesting
controller times out, resulting in a constant No
Report. ELMC response time delay is a function
of controller circuitry and is not linear. Always
start with longer time-out, then reduce time to
an acceptable value.
Figure 4-16 DS1/E1, DS3, OC3 Radio ELMC Remote Time-Out Constant Provisioning
4-40
SELECT TIME LOCALLY FOR ELMC RESPONSE TO A REQUEST
FOR STATUS BEFORE TRYING AGAIN. SELECT SHORTER TIME
(5 SECS) FOR SHORTER SYSTEMS (10 HOPS OR LESS).
SELECT LONGER TIME (10 SECS) FOR SYSTEMS WITH 10 HOPS
OR MORE.
3 secs
4 secs
5 secs
6 secs
7 secs
8 secs
9 secs
10 secs
OK
F5 F6
Analog Monitor Performance
REMOTE STATUS ALARM
Retrieving Provisioning
RECEIVER
B
STATUS
RECEIVER
No Report
Note
Current time-out is 3 secs
Cancel
F7 F8 F9
Station Alarm User Control
A B
STATUS
I/O
MESSAGE DISPLAYED FOR LENGTH
PWR
OF TIME SELECTED DURING TIME LOCAL
RADIO IS ATTEMPTING TO COMMUNICATE
WITH REMOTE ADDRESS VIA ELMC.
MESSAGE DISPLAYED FOR LENGTH
OF TIME SELECTED IF THERE IS NO
RESPONSE TO REQUEST FOR STATUS/
CONTROL/PROVISIONING.
Provisioning
LMW-4024A-SM
08/08/02
COMMON
A B