Alcatel MDR-8000 User Manual page 59

MISMATCH BETWEEN PROVISIONING DATA WRITTEN
TO I/O INTERFACE BY CONTROLLER AND THEN READ
BY CONTROLLER.
1. REPROVISION AND SAVE.
2. REPLACE I/O INTERFACE MODULE.
CLICK HERE, DROP DOWN LIST
DISPLAYS ONE OR MORE MESSAGES.
TROUBLESHOOT AS FOLLOWS.
CONTROLLER MODULE RESET.
MODULE IS PRESENT, BUT
CANNOT COMMUNICATE WITH
2
CONTROLLER ON I C BUS.
1. REMOVE AND REPLACE
MODULE
INDICATING READ FAIL ON
INVENTORY SCREEN.
2. REMOVE AND REPLACE
CONTROLLER.
MESSAGE
A/B SIDE LIO SPI FAIL
A/B SIDE RCV SPI FAIL
A/B SIDE DS1 SPI FAIL
FAN ALARM
DS3 LOOPBACK ON
A/B HIGH/LOW POWER LOCK
A/B TX/RX/OR I/O OVERRIDE
EEPROM PROV DOES NOT
MATCH MODULE PROV
Figure 5-10 Troubleshooting DS3 Radio Common Alarms
COMMON
STATUS
I/O On Line
DS1 Provisioning
Power Regulator
Command Path
Off Normal
Controller
Inventory
Prov. Mismatch
Radio ID
Ring Broke
EQUIPMENT
MALFUNCTION
WITHIN RING
MEANING
LOST COMMUNICATION
BETWEEN CONTROLLER
AND I/O INTERFACE
LOST COMMUNICATION
BETWEEN CONTROLLER
AND I/O INTERFACE/RCVR
LOST COMMUNICATION
BETWEEN CONTROLLER
AND I/O INTERFACE
FAN OR FAN CONTROL
MODULE FAILED
FUNCTION ENABLED ON
CONTROL SCREEN
FUNCTION ENABLED ON
CONTROL SCREEN OR FRONT
PANEL ON CONTROLLER
PROVISIONING ON
CONTROLLER DOES NOT
MATCH PROVISIONING
SCREEN
VOLTAGE REGULATION FAILURE
OR EXCESSIVE LOAD.
1. CYCLE POWER
2. CHECK FUSE
3. CHECK OUTPUT POWER
4. REPLACE POWER SUPPLY
LOSS OF COMMUNICATION BETWEEN
CONTROLLER AND FAREND
CONTROLLER.
A B
1. VERIFY RCVR OPERATION.
2. REPLACE CONTROLLER.
CONTROLLER PROVISIONING DOES NOT
MATCH MODULE PROVISIONING.
REPROVISION TO MEET SYSTEM
REQUIREMENTS.
1. IF A AND B I/O INTERFACE ALARMS
ARE ACTIVE, REPLACE CONTROLLER.
2. REPLACE I/O INTERFACE.
MISMATCH BETWEEN LOCAL PROVISIONED
RADIO ID AND FAR END RADIO ID.
ACTION
REMOVE/REPLACE
1) I/O INTERFACE
2) CONTROLLER
REMOVE/REPLACE
1) RCVR
2) I/O INTERFACE
3) CONTROLLER
REMOVE/REPLACE
1) I/O INTERFACE
2) CONTROLLER
REMOVE/REPLACE
FAN/FAN ASSEMBLY
DISABLE FUNCTION
ON CONTROL SCREEN
DISABLE FUNCTION
ON CONTROL SCREEN
OR CONTROLLER
FRONT PANEL
PROVISION TO MATCH
PROPER SYSTEM
REQUIREMENTS
LMW-1029B
02/27/02
5-15