Pyle PLMRA210BT User Manual

Warnings
•
Read these instructions and keep them for future reference.
•
Carefully follow instructions and follow directions carefully.
•
Keep the amplifier dry, as some liquids may contain minerals that corrode electronics circuitry.
•
Clean amplifier housing only with a slightly damp cloth. No chemicals or solutions.
•
Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions.
•
Do not install near any heat source such as radiators, stoves, or other electrical devices that produce heat.
•
Prevent any cables, wired or power cord from being walked on, bent, stretched or pinched, particularly at
the plug or at the point where connects to the amplifier.
•
When uncertain about specifications, please first consult the Pyle Audio website and see the FAQs.
•
Ensure this unit is placed on a stable and flat surface and can accommodate the weight of this unit.
•
Unplug this unit during lightning storms or when it is unused for an extended period of time.
•
Do not leave this device unattended when powered on.
•
Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged
or malfunctions in any manner. This would include damage to the power supply cord or plug.
If the unit is likely to undergo excess vibration through use, your must properly install the unit securely. Damage
caused by insufficient support is not covered by the warranty. To prevent damage to the unit's panels, always
use protective plastic cups or washers before tightening mounting bolts.
Service may be obtained from an authorized Pyle Audio service center. Contact Pyle Audio and
make sure you have a receipt as proof of purchase along with the defective unit. You will be then
instructed to send or deliver the malfunctioning unit to an authorized center. They will handle the
necessary paperwork and repair. Remember to transport your unit in the original factory packaging.
PLEASE NOTE: Users must ensure that any type of smoke and related substances are not allowed to
enter the amplifier. Smokey air is corrosive and prolonged exposure will cause irreparable damage to
your amplifier. Take precaution before reconnecting to a power supply. Be aware that when any
equipment is taken from a cold to humid location, condensation may occur inside. Always allow time
for the equipment to attain the same temperature as its environment before reconnecting to a
power supply.
Elite Series Waterproof Amplifiers