Selecting Additional Functions; Speedperfect Á; Ecoperfect À; Less Iron - Siemens WD15H540DN Instruction Manuals

Selecting additional functions

en
\
Selecting additional
functions
Select the desired additional function
S e l e c t i n g a d d i t i o n a l f u n c t i o n s
with the × (Option) button, touch this
button until your desired option frame
flashes and then activate the chosen
option by touching the è (Select)
button. The selection bar appears at the
bottom of the frame, indicating that the
option is selected. Touch the è (Select)
button again to deactivate this option.
You can repeat operation to select more
additional functions which are available
for the selected programme. If there is
no other action, the function frame
stops flashing and comes on after
several seconds. The additional function
is sucessfully selected .
speedPerfect á
(: For a shorter wash time with a
comparable washing effect to the
standard programme.
Do not exceed maximum load.
Note:
Overview of programmes ~ Page 20
26
ecoPerfect à
0: Energy-optimised washing by
reducing the temperature while
achieving a consistent washing result.
The washing temperature is
Note:
lower than the selected temperature.
For special hygiene requirements, it is
recommended that a higher
temperature be selected or the
speedPerfect á additional function.

Less iron {

8: Special spin sequence with
subsequent fluffing. Gentle final spin –
residual moisture in the laundry
increased slightly.

Stains

@: The Stains additional function for
treating special stains can be selected.
A total of 6 different stains can be
selected. The washer dryer adjusts the
washing temperature, drum movement
and soaking time specifically to the type
of stain. Hot or cold water, gentle or
intensive washing control and long or
short soaking provide the wash
programme with a special sequence for
each type of stain. The result: the best
treatment for each stain.

Rinse plus l

H: Additional rinse cycle. For areas
with very soft water or for an even better
rinsing result.
Select Rinse plus l using the
Note:
× (Option) button. Then touch the
è (Select) button to activate the
function and touch the è (Select)
button down for the desired number of
rinse cycles (max. 3 cycles, depending
on the selected programmes).
2+3 l: Default rinse cycle + additional
rinse cycle.