Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Nilfisk-Advance C30
Summary of Contents for Nilfisk-Advance C30
- Page 1 TECHNICAL MANUAL...
- Page 3 INSTALLATION, USE AND MAINTENANCE MANUAL GENERAL INFORMATION Purpose of this manual This installation, use and maintenance manual is an integral and essential part of the vacuum cleaner system. Its purpose is to provide all necessary information to allow the installer to install the system in full compliance with the manufacturer’s specifications, the user to operate the system in the safest and most independent way, and maintenance technicians carrying out programmed maintenance operations to ensure the correct operation of machinery and the system as a whole.
- Page 4 INSTALLATION, USE AND MAINTENANCE MANUAL This manual has been compiled to permit use of the system in optimal conditions respecting the conditions of guarantee. You are advised to read it carefully. RECOMMENDATIONS FOR USE • Vacuum units are destined for use in residential buildings. Their use during building work may cause serious deterioration that is not covered by the guarantee.
-
Page 5: Table Of Contents
INSTALLATION, USE AND MAINTENANCE MANUAL CONTENTS Description of the centralized vacuum cleaning system 1.1. Exploded diagram of main vacuum unit 1.2. Accessories supplied 1.3. Technical characteristics 1.4. Description of user interface Installation 2.1. Choice of installation position for main vacuum unit 2.2. -
Page 6: Description Of The Centralized Vacuum Cleaning System
INSTALLATION, USE AND MAINTENANCE MANUAL 1. DESCRIPTION OF THE CENTRALIZED VACUUM CLEANING SYSTEM 1.1 Exploded diagram of main vacuum unit... -
Page 7: Accessories Supplied
INSTALLATION, USE AND MAINTENANCE MANUAL MAIN VACUUM UNIT 1. Dust collection container 2. Container release button 3. Channelling cone 4. Filter retention ring 5. Secondary filter in washable polyester 6. Container locking handle 7. Central section 8. Anti-intrusion grille 9. Lower anti-vibration gasket 10. -
Page 8: Technical Characteristics
INSTALLATION, USE AND MAINTENANCE MANUAL 1.3 Technical characteristics DIAMOND DIAMOND COMPRESSOR Series Model Maximum surface area (m³) Smart electronics Self-cleaning function Air expulsion Incorporated silencer IP protection rating Power supply V AC 0/0 0/0 Frequency Hz 0/0 170 100 Motor power W 170 External SB fuse (AM) A Socket power supply V dc... - Page 9 INSTALLATION, USE AND MAINTENANCE MANUAL DIAMOND DIAMOND COMPRESSOR...
-
Page 10: Description Of User Interface
INSTALLATION, USE AND MAINTENANCE MANUAL 1.4 Description of user interface 1. GREEN LED – When lit indicates the presence of a power supply, and the vacuum unit is ready for use. 2. RED LED – When lit indicates a warning clarified with a message on the display. . -
Page 11: Installation
INSTALLATION, USE AND MAINTENANCE MANUAL 2.INSTALLATION ATTENTION: The entire system must be installed by qualified personnel in full compliance with standards of workmanship and with applicable standards and regulations. 2.1 Choice of installation position for main vacuum unit The choice of installation position must be based on these criteria: •... -
Page 12: Installation Of Main Vacuum Unit
INSTALLATION, USE AND MAINTENANCE MANUAL 2.3 Installation of main vacuum unit After moving the main vacuum unit still packed to the selected room, proceed to unpack paying attention to the indications on the package and begin the installation steps as follows: 1. - Page 13 INSTALLATION, USE AND MAINTENANCE MANUAL CAUTION: Electrical connections must be made only by qualified personnel. 7. Connect the two coloured poles (black, red) of the 7x0.2 cable to the two wires of the 12 V DC low- voltage command of the INLETS LINE. Power supply 20 V 12 V 8.
-
Page 14: Reversibility Of Suction And Outlet Connections
INSTALLATION, USE AND MAINTENANCE MANUAL 2.4 Reversibility of suction and outlet connections Main vacuum units are normally supplied with connections for air inlet and outlet pipes on the right. If necessary, this direction can be modified by independently moving the air inlet and outlet connections to the left. - Page 15 INSTALLATION, USE AND MAINTENANCE MANUAL To reverse the outlet connector, proceed as follows: ATTENTION: Before carrying out this operation, it is compulsory to unplug the unit from the 230 V power supply wall socket. 1. Unscrew the screws and remove the two side covers (with and without expulsion). 2.
-
Page 16: Self-Cleaning Function
INSTALLATION, USE AND MAINTENANCE MANUAL 3. SELF-CLEANING FUNCTION Top models have a self-cleaning system with filter that can operate at intervals programmable according to requirements. Maintenance is therefore limited to the replacement of the collection bag. In the USER MENU of the interface there is this submenu: SELF-CLEANING only if the self-cleaning function has been activated on the machine. -
Page 17: Maintenance
INSTALLATION, USE AND MAINTENANCE MANUAL 4. MAINTENANCE ATTENTION: Before carrying out any maintenance operations it is compulsory to unplug the unit from the 230 V the power supply wall socket and to put on protective gloves and a facemask. For versions with a user interface, the machine indicates when the dust container must be emptied or the filter cleaned after a time interval that is programmed by the user (for programming instructions see chart on page 20). -
Page 18: Manual Filter Cleaning
INSTALLATION, USE AND MAINTENANCE MANUAL 4.2 Manual filter cleaning The main vacuum unit has a filter cartridge that filters dust, protection the vacuum motor. It is important to make monthly checks on the condition of this filter. On models with the Self-cleaning function, annual inspections must be made on the filter to ensure that it is undamaged and to check if it needs washing (if washed, the filter must be dry before being replaced). -
Page 19: Safety Components
INSTALLATION, USE AND MAINTENANCE MANUAL 5. SAFETY COMPONENTS 5.1 Protection fuse All main vacuum units are protected by a fuse that interrupts the power supply to the motor in case of malfunctions or electrical problems. To replace the fuse, unscrew the fuse-holder located above the power supply cable (see diagram on page –... -
Page 20: Programming The User Interface
INSTALLATION, USE AND MAINTENANCE MANUAL 6. PROGRAMMING THE USER INTERFACE 6.1 General information The user interface supplied is already programmed for the requirements of normal use. If necessary, the preset parameters can be modified to cater for individual needs. Hours of operation Programmable parameters Minimum Preset... -
Page 21: Display Of Personalized Maintenance Parameters
INSTALLATION, USE AND MAINTENANCE MANUAL • Dust container emptying: This procedure is used to modify the parameter that controls alarm operation, set by default at 10 hours on models 0 and 0. Enter the USER MENU by pressing the SET button when the display shows the STANDBY message. -
Page 22: Most Frequent Problems
INSTALLATION, USE AND MAINTENANCE MANUAL 7. MOST FREQUENT PROBLEMS 7.1 The main vacuum unit does not work… • Check the 20 V power supply. • Check that the low-voltage command is correctly connected to the black and red poles of the main unit, in case of electrical connections to the sockets. -
Page 23: Decommissioning
INSTALLATION, USE AND MAINTENANCE MANUAL 9. DECOMMISSIONING When the device has terminated its cycle of use and must be decommissioned, follow these instructions to protect the environment: The presence of this symbol on the product or on the pack indicates that the product must not be treated as normal household refuse, but must be taken to a suitable collection centre for the recycling of electrical and electronic devices. -
Page 24: Declaration Of Ec Conformity
The instruction manual indicates in particular the standards for the installation, use and maintenance of this device. The responsible to form the relevant technical file is Mr ....at the company address. Nilfisk-Advance A/S Sognevej 2 20 Brøendby 7218210 Denmark... - Page 25 Company with UNI EN ISO 9001:2000 Certified Quality System Nilfisk-Advance A/S Sognevej 2 20 Brøendby 7218210 Denmark www.nilfisk.com...