Huawei Quidway S2700 Series Quick Start Manual page 28

Quidway S2700&S3700&S5700&S6700 Series Ethernet
Switches
Quick Start
As shown in
can press the mode switching button to switch the display modes of interface indicators. The
status of a mode indicator represents the display mode of the related interface indicator. For
example, the mode indicator of S3700-28TP-PWR-EI is off and the interface indicators are in
STAT state by default. When you press the mode switching button once, the mode indicator
turns green and the related interface indicator enters the speed state. When you press the mode
switching button for a second time, the mode indicator turns orange and the related interface
indicator represents the PoE power status. When you press the mode switching button for a third
time, the mode indicator turns red and the related interface indicator represents the stack status.
When you press the mode switching button for a fourth time, the mode indicator restores to the
default state (off). If you do not press the mode switching button within 45 seconds, the mode
indicator automatically restores to off.
The following table describes the meanings of indicators.
Table 2-11 Description of indicators in different modes
Display Mode
STAT
Speed
PoE
Stack
Issue 01 (2011-10-26)
Figure 2-9, the button marked "5" is the mode switching button. On an S3700, you
Status
Off
Green
Blinking green
Off
Green
Blinking green
Off
Green
Blinking green
Off
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Product Hardware Introduction
Description
The interface is not connected or
has been shut down.
The interface is connected.
The interface is sending or
receiving data.
The interface is not connected or
has been shut down.
The interface speed is 10/100
Mbit/s.
The interface speed is 1000 Mbit/
s.
The interface does not provide
remote power.
The interface is providing remote
power.
l The power of the powered
device (PD) exceeds the power
supply capability of the port or
exceeds the threshold.
The stack ID of the member
switch is not the number of an
interface in the off state.
23