Table of Contents
Advertisement
Gas conversion
DANGER: Before starting any
work on the gas installation,
disconnect the gas supply.
There is the risk of explosion!
In order to have the appliance's gas type
changed, all the injectors must be changed
and the flame adjustment for all valves must
be set at the reduced flow rate position.
Changing the injectors
1. Take off burner cap and burner body.
2. Unscrew injectors by turning them
counterclockwise.
3. Fit new injectors.
4. Check all connections for secure fitting
and tightness.
New injectors have their position
marked on their packing or refer to
the Injector table.
1 Flame failure device (model dependent)
2 Spark plug
3 Injector
4 Burner
Unless there is an abnormal
condition, do not attempt to remove
the gas burner taps. You must call
an authorised service agent if it is
necessary to change the taps.
Page 15
Reduced gas flow rate setting for taps
1. Ignite the burner that is to be adjusted and
turn the knob to the reduced position.
2. Remove the knob from the gas tap.
3. Use an appropriately sized screwdriver to
adjust the flow rate adjustment screw.
For LPG (Butane - Propane) turn the screw
clockwise. For natural gas, you should turn
the screw counter-clockwise once. The
normal length of a straight flame in the
reduced position should be 6-7 mm
4. If the flame is higher than the desired
position, turn the screw clockwise. If it is
smaller turn anticlockwise.
5. For the last control, bring the burner to
both the high-flame and reduced positions
and check whether the flame is on or off.
Depending on the type of gas tap used in
your appliance the adjustment screw
position may vary.
1
Flow rate adjustment screw
1
Flow rate adjustment screw
If the gas type of the unit is
changed, then the rating plate
that shows the gas type of the
unit must also be changed.
Advertisement
Table of Contents
