Beko HIDG 95225 SX AU User Manual

Hob gas 5 b


Quick Links

HIDG 95225 SX AU

User manual

Page 1
Document Number : User Manual / 069538


Table of Contents

Summary of Contents for Beko HIDG 95225 SX AU

  • Page 1: User Manual

    HOB GAS 5 B HIDG 95225 SX AU User manual Page 1 Document Number : User Manual / 069538...
  • Page 2 Dear Customer, Your new Beko hob was manufactured in a state of the art facility and has passed the strictest quality control procedures. Please read this manual carefully before installing and using your hob for the first time and then store it within easy reach for future reference. Safety instructions must be strictly followed.
  • Page 3: Table Of Contents

    Table of contents 1 Important safety instructions 4 Preparation General safety Tips for energy saving Safety when working with gas Initial use What to do when you smell gas First cleaning of the appliance Electrical safety Product safety 5 How to use the hob Intended use General information about cooking Safety for children...
  • Page 4: Important Safety Instructions

    1 Important safety instructions This section contains safety Control that the product  instructions that will help you function knobs are switched off avoid risk of injury and damage. after every use. All warranties will become void if Safety when working with gas you do not follow these Any works on gas equipment ...
  • Page 5: What To Do When You Smell Gas

    Prolonged intensive use of the Do not operate any electrical appliance may call for buttons (e.g. lamp button, door additional ventilation, for bell and etc.) Do not use fixed example increasing the level or mobile phones. Risk of of the mechanical ventilation explosion and intoxication! where present.
  • Page 6: Product Safety

    Our company shall not be In case of any damage, switch  liable for any problems arising off the product and disconnect due to the product not being it from the mains. To do this, earthed in accordance with the turn off the fuse at home.
  • Page 7: Intended Use

    Unattended cooking on a hob Intended use  with fat or oil can be This product is designed for  dangerous and may result in domestic use. Commercial fire. NEVER try to extinguish a use will void the guarantee. fire with water, but switch off This appliance is for cooking ...
  • Page 8: Disposing Of The Old Product

    Compliance with RoHS Disposing of the old product  Compliance with the WEEE Directive: The product you have Directive and Disposing of the purchased complies with EU Waste Product: RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive.
  • Page 9: General Information

    2 General Information Overview CONTROL KNOBS FOR RELEVANT BURNERS AUXILIARY BURNER SEMI-RAPID BURNERS RAPID BURNER TRIPLE CROWN BURNER The manufacturer strives for continuous improvement. For this reason, technical specifications, text and illustrations in this manual are subject to change without notice.
  • Page 10: Technical Specifications

    Technical specifications Voltage / frequency 220-240 V ~ 50 Hz Cable type / section H05RR-FG 3 x 0,75 mm Cable length max. 2 m Gas type Natural Gas (NG) / pressure G20/2.0 kPa Total gas consumption 12.9 kW Converting the gas type Liquid Petroleum Gas (LPG) / G30/2.8-3.0/3.7 kPa pressure External dimensions (height / width / depth)
  • Page 11: Installation

    3 Installation  Installation must be in accordance with this This appliance can also be used in a free instruction manual, AS 5601.1 gas standing position. Allow a minimum installations' for installation and pipe sizing, distance of 750 mm above the hob local gas fitting regulations, municipal surface.
  • Page 12: Room Ventilation

    STANDARD COUNTER TOP 50 - 60 mm. 30 - 40 mm. SECURING BRACKET AND SCREW Baffle installation THICKER COUNTER TOP Top thickness SECURING BRACKET AND SCREW Hose connection Flexible hose assembly (if used) must comply with AS/NZS 1869 Class B or D, be of appropriate internal diameter, be kept as short as possible (not to exceed 1.2 meters), must not be kinked or in contact with any hot...
  • Page 13: Installation And Connection

    Installation and connection The power cable plug must be The product must be installed in accordance within easy reach after installation with all local gas and electrical regulations. (do not route it above the hob). Electrical connection Plug the power cable into the socket. Connect the product to a grounded outlet/ line protected by a fuse of suitable capacity Gas connection...
  • Page 14: Final Check

    5. For other minor adjustments or if the the clamp and the screws supplied. appliance does not perform correctly contact: Beko A and NZ Pty Ltd 1300 282 Natural Gas: the supplied regulator must be fitted to the appliance inlet connection. Gas pressure must be adjusted to 1.0 kPa when...
  • Page 15: Gas Conversion

    Gas conversion DANGER: Before starting any Reduced gas flow rate setting for taps work on the gas installation, 1. Ignite the burner that is to be adjusted and disconnect the gas supply. turn the knob to the reduced position. There is the risk of explosion! 2.
  • Page 16: Future Transportation

    Future Transportation Keep the appliances original carton and transport the appliance in it. Follow the instructions on the carton. If you do not have the original carton, pack the appliance in bubble wrap or thick cardboard and tape it securely. Secure the caps and pan supports with adhesive tape.
  • Page 17: Preparation

    4 Preparation Tips for energy saving Initial use The following information will help you to use First cleaning of the appliance your appliance in an ecological way, and to save energy: The surface might get damaged by some detergents or cleaning ...
  • Page 18: How To Use The Hob

    5 How to use the hob General information about cooking Gas cooking  The size of the cooking vessel and the DANGER flame must be suited to each other. Adjust Risk of fire by overheated oil! the gas flames so that they do not extend When you heat oil, do not leave it past the bottom of the cooking vessel and unattended.
  • Page 19: Igniting The Gas Burners

    Igniting the gas burners 1. Keep the burner knob pressed in. 2. Turn the knob counter clockwise to the large flame symbol. The gas is ignited with the spark created. 3. Adjust the knob to the desired cooking power. Turning off the gas burners Turn the keep warm zone knob to off (upper) position.
  • Page 20: Maintenance And Care

    If the appliance produces unusual odour, yellow tipping flame, flame lifting off the burner or is not performing as per the original installation, or for service contact: Beko A and NZ Pty Ltd 1300 282 356. Page 20...
  • Page 21: Troubleshooting

    7 Troubleshooting Problem solving guide—before calling for technical support Product emits metal noises while heating and cooling. When the metal parts are heated, they may This is not a fault. expand and cause noise. There is no ignition spark No current. Check fuses in the fuse box.

Table of Contents