Setting The Time; Watching Tv - Mirage smartSTREAM BOX2IP Quick Start Manual

Access the sub-menu Parental Lock as follows:
1. Press the MENU key.
2. Select the menu System Setup.
3. Select Parental Lock and confirm by pressing OK.
After entry of password, you may
− set if access to the sub-menus is protected by password,
by selecting the Menu Lock and selecting Off or On by using the keys V+ / V-;
− set if certain channels are to be locked by a PIN,
by selecting PIN and selecting Off or On by using the keys V+ / V-; or
− change the password:
Select the field New Password.

Enter a new password.

Go to the field Confirm Password.

Again enter the new password.


Predefined, both the menu and the program lock are On. In addition, the default
password is 0000.
4. Press OK to save your changes and to leave the sub-menu.
3.7

Setting the Time

Reasonable operation of the receiver requires setting of system time. By default, the receiver is set to
3
GMT Usage, i. e. date and time are taken from the received signal. Time zone is set to GMT + 1 hour
(+ 1:00) by default. Required changes can be made in the sub-menu Time:
1. Select the menu System Setup.
2. Select the sub-menu Time and confirm by pressing OK.
3. Select the item GMT Usage and switch on or off GMT Usage.
On = automatic time setting via satellite signal is activated.
Off = automatic time setting via satellite signal is deactivated.
If automatic time setting (GMT Usage) is switched off, then date and time should be manually entered:
For this, select the item Date and press OK.
1.
2. Select the position to be changed, and enter the current date by using the numeric keys.
3. Then, select the item Time,
4. Select the position to be changed and enter the current time by using the numeric keys and press
OK.
3.8

Watching TV

Select the desired channel by using the keys PR+ and PR-. With each change of channel, an infor-

mation window with information on the current channel will be displayed or
Press the OK key to display a selection window with all available channels.

Select the channel list with the desired channel by using the keys V+ / V-.

Select the channel to be displayed by using the keys PR+ and PR- for single steps or PAGE+

and PAGE- for steps of ten, and confirm your selection by pressing OK.
The channel will be correspondingly switched.
3
GMT = Greenwich Mean Time
Operation of the Receiver
9