Motorola Symbol CS3000 Series Setup Manual page 3

4. Bluetooth Connection Pairing
If your host device does not support Bluetooth communications, a third-party Bluetooth adapter will be
required. Contact support@5starstudents.com
1. Press the scan (+) button to wake the scanner
2. Press and hold the Bluetooth button (small round button) for 5 seconds. The scanner will beep
and button starts blinking to indicate the scanner is ready for pairing
3. On the host PC or mobile device, launch the appropriate Bluetooth pairing program and start the
Bluetooth device discovery mode*
4. Select the CS3070 from the discovered device list. The host device may prompt you to scan a
passkey it generated
5. Scan the required digits from the
then scan the Enter key
The Bluetooth button will blink slowly to indicate that the scanner is paired with the host.
* Pairing guides for specific devices are available online. After login, go to the Help/How-to Docs page to access.
Unpairing
To unpair the scanner from a host, press the Bluetooth button. Upon unpairing, the Bluetooth button
will stop blinking. You may need to remove the scanner from the host's list of Bluetooth devices and
repeat the pairing instructions above to reconnect the scanner.
To enter batch scanning mode, the scanner cannot be in Bluetooth discovery mode or paired to a
Bluetooth host (i.e. blue light flashing).
for more information.
Numeric Bar Codes section that correspond to the passkey,
Page 3
Symbol CS3000 Series – Setup Guide
5-Star Students