Motorola Symbol CS3000 Series Setup Manual page 2

In batch mode only: to delete a bar code aim the scanner at the bar code and press the delete (-)
button. Scanner beeps and LED turns amber to indicate a successful delete. LED will turn red if bar
code is not found.
To clear all bar codes from the unit, press and hold the delete (-) button for approximately 6-7 seconds.
You'll hear several long beeps indicating the scanner has been cleared. You can also scan the Clear
Data barcode on the provided Batch Mode card instructions.
This scanner cannot scan bar codes when connected to a host computer via the USB cable
* CS3070 model only, see Bluetooth connection pairing section
3. Set Date and Time
Each scanner comes pre-configured with the current date and time set, based on your school's time
zone. If the scanner is not used regularly, you may need to reset the date and time on the unit to ensure
accuracy.
Set Date
Scan the Set Date bar code, then scan six numeric digits in the format mmddyy from the
Codes section
Set Time
Scan the Set Time bar code, then scan four numeric digits in the format hhmm from the
Codes section, representing the time according to the 24 hour clock. For example, to set the time to
3:07 in the afternoon, scan 1, 5, 0, 7
Cancel Date and Time Setting
Scan the Cancel Set Date/Time bar code to cancel the date and time settings
Set Date
Set Time
Cancel Set Date/Time
Page 2
Symbol CS3000 Series – Setup Guide
5-Star Students
Numeric Bar
Numeric Bar