Advertisement
B-11) Shock Sensor Bypass
Press button (1) once while the system is disarmed and then press button (1) again within 2
seconds.
B-12) Boot Release/Channel 3 Output/Total Closure Output (optional feature)
Channel 3 output is often used to operate a boot release or can be configured to operate Total
Closure.
B-13) Remote Engine Start for Automatic Transmissions
Press button (3) for over 3 seconds to remote start.
If the remote start fails more than twice,
please check up the following:
a> The remote start will be activated only under the arm mode.
b> Bonnet Open
c> Boot Open
d> Door Open
e> Foot brake pushed down
f> Hand brake off
* The engine will shut off in the following cases to protect your vehicle after the remote start.
a> Bonnet Open
b> Door Open
c> Boot Open
d> Foot brake pushed down
e> Hand brake released
* After remote engine start has been used, please follow the following steps to enter the
vehicle.
a> Disarm/unlock first.
b> Insert the car key into the ignition then switch it to <On>, not Start.
The engine will shut down if you apply the foot or hand brakes before inserting the car key into
the ignition and switching <On>.
B-14) Reservation Mode (Remote Engine Start for Manual Transmissions Only)
For manual transmission cars reservation mode is used for safety reasons. Ensure that Car Type
is set to Manual (please refer to # 11 in Programming Option Table)
1) Follow the below procedure to set up the reservation mode.
a> After arriving at the destination, leave the ignition on and shift the gear to the neutral
position.
b> Pull up the hand brake.
c> Remove the key from the ignition. The engine will keep running.
d> Exit the vehicle and close the door after Step c.
The engine will shut down and the
reservation mode is set up.
Reservation mode must be set up as above every time before exiting manual
Important:
transmission cars in order to activate the remote start.
2) Important requirements to activate the reservation mode:
a> The transmission gear must be placed in the neutral position.
b> The hand brake must be pulled up.
c> Do not set the reservation mode when people are in vehicles.
d> Do not activate the remote engine start when people are in vehicles
e> The remote engine start will only be activated when the system is armed.
3) Cancel the Reservation Mode
The reservation mode will be cancelled if any of the following cases happen.
a> The parking brake is released when the engine is running.
b> Button (3) is pressed for 3 seconds between Step 3 and 4 during setting of the reservation
mode.
c> The valet mode is applied after completing the reservation mode.
5
Advertisement
