Wired Headphones; Wireless Fm Modulator - Audiovox VOD1023 P Operation Manual

Wired Headphones

There are two 1/8" headphone jacks on the VOD1023 that can be used with any standard wired stereo headphones. These jacks
are controlled by the volume up / down buttons on the VOD1023 or on the remote control.

Wireless FM Modulator

The VOD1023 is equipped with built-in wireless FM Modulator*, that allows you to listen to the VOD1023 audio signal by tuning your
vehicle's radio to the selected frequency, (88.3, 88.7, 89.1, 89.5, 89.9MHz). This feature is accessed by using either the FM transmitter
buttons on the remote (On/Off, Channel Select) or the FM Select button on the unit.
AV1 Input
The AV1 video input may be connected to a Video cassette Player (VCP), video game system, or other audio / video devices. To
access the A/V1 input, turn the VOD1023 on and press the source button on the VOD1023 or the Source button on the remote
control until "AV1" is displayed on the screen. Turn the video source component on with its power button or remote control. The
VOD1023 is now ready to play the audio and video signals from the source connected to AV1 input. The AV1 input requires a 8010730
cable.
*NOTE : In certain areas where there are a large number of FM radio stations (e.g. large cities, urban areas), the reception of the FM
signal from the overhead pod may not be satisfactory, resulting in static, distorted sound or signal bleed thru from strong local radio
stations. This is not a defect in the product, but the result of a stronger local radio station overpowering the wireless FM transmitter
in your overhead pod.
If wireless reception is unsatisfactory, an optional wired relay box (Audiovox P/N SIRSWB) can be installed which will improve audio
quality. Please contact the installer if this is the case with your product.
128-7255A
17 of 37