Saw Chain - Makita BUC300 Instruction Manual

OPERATION
Lubrication
1
2
010920
Saw chain is automatically lubricated when the tool is in
operation.
Check the amount of remaining oil in the oil tank
through the oil inspection window.
To refill the tank, remove the cap from the oil tank
opening.
After refilling the tank, always screw the provided oil
tank cap on the chain saw.
CAUTION:
When filling the chain saw with chain oil for the
•
first time, or refilling the tank after it has been
completely emptied, add oil up to the bottom edge
of the filler neck. The oil delivery may otherwise be
impaired.
As a saw chain oil, use oil exclusively for Makita
•
chain saws or oil available in market.
Never use oil including dust and particles or
•
volatile oil.
When pruning trees, use botanical oil. Mineral oil
•
may harm trees.
Never force the chain saw when pruning trees.
•
Before cutting out, make sure that the provided oil
•
tank cap is screwed in place.
010940
Hold the chain saw away from the tree. Start it and wait
until lubrication on saw chain is adequate.
Bring the lower guide into contact with the branch to be
cut before switching on. Cutting without bringing the
lower guide into contact with the branch may cause the
guide bar to wobble, resulting in injury to operator.
Saw the wood to be cut by just moving it down.
1. Oil tank cap
4
2. Oil tank opening
3. Oil inspection
window
( for refilling the
tank with oil)
3
4. Oil inspection
window
WORKING WITH THE CHAIN SAW
The first time user should, as a minimum practice, do
cutting logs on a saw-horse or cradle.
Pruning trees
1
010921
CAUTION:
Keep all parts of the body away from the saw
•
chain when the motor is operating.
Hold the chain saw firmly with both hands when
•
the motor is running.
Do not overreach. Keep proper footing and
•
balance at all times.
Bring the lower guide into contact with the branch to be
cut before switching on. Cutting without bringing the
lower guide into contact with the branch may cause the
guide bar to wobble, resulting in injury to operator.
1
008576
When cutting thick branches, first make a shallow
undercut and then make the finish cut from the top.
001742
If you try to cut off thick branches from the bottom, the
branch may close in and pinch the saw chain in the cut.
If you try to cut off thick branches from the top without a
shallow undercut, the branch may splinter.
14
1. Lower guide
2