Guide Bar - Makita BUC300 Instruction Manual

1
011229
CAUTION:
Before using battery adapter, read all instructions
•
on tools using battery.
When charging a battery cartridge, first remove it
•
from the battery adapter and then charge it. It is
not allowed to charge the battery cartridge while
using battery adapter.
Installing or removing battery adapter
Always switch off the tool before insertion or
•
removal of the battery adapter.
To remove the battery adapter, slide it from the
•
tool while sliding the button on the adapter.
To install the battery adapter, align the tongue on
•
the battery adapter with the groove in the housing
and slip it into place. Insert it all the way until it
locks in place with a little click. If you can see the
red indicator on the upper side of the button, it is
not locked completely.
CAUTION:
Always install the battery adapter fully until the red
•
indicator cannot be seen. If not, it may accidentally
fall out of the tool, causing injury to you or
someone around you.
Do not install the battery adapter forcibly. If the
•
adapter does not slide in easily, it is not being
inserted correctly.
The way of removing or installing a battery
•
cartridge from or on the battery adapter is the
same as that of removing or installing it from or on
the tools.
Press down the hook securely as far as it will go
•
when the battery adapter is hooked on the waist
belt and similar objects.
Arm cord hook (Accessory)
CAUTION:
Do not attach the holder of arm cord hook to other
•
than the extension cord. Failure to do so may
cause an accident or personal injury.
Using the arm cord hook helps to minimize a risk of
cutting off the extension cord unexpectedly caused by
the loose extension cord.
1. Hook
2. Belt
2
1. Arm cord hook band
2. Holder
3. Extension cord (Battery adapter)
4. Adapter (Battery adapter)
011585
Attach firmly the arm cord hook band placing around
your arm and pass the extension cord through the
holder. The length of the arm cord hook band is
adjustable.
NOTE:
Do not pass the extension cord through the band.
•
Do not force the opening of the holder. Failure to
•
do so may cause deflection and damage to it.
Spike bumper (optional accessory)
014819
To install spike bumper, perform the following steps:
1. Remove the sprocket cover, saw chain and guide
bar as described in this instruction manual.
2. Fit the holes of spike bumper along with the holes
on the chainsaw.
3. Tighten them firmly with screws.
13
1
2
4
3