Advertisement
FEATURES
Easy-to-use tiltable head.
The head is tiltable up to 25 degree for ease of side trimming.
Since two Ni-MH batteries are built in, the clipper can be used for about 50 minutes with a full charge.
Cutting length can be adjusted to 3mm, 6mm, 9mm, 12mm by using the cropped hair attachments.
Cordless 5 hour charging/AC type.
NAMES OF PARTS (Fig.1)
Cropped hair attachment
Knob
Head
Switch position display
Charge indicator lamp
PREPARATIONS BEFORE USING
PROCEDURE FOR CHARGING
Before using, first charge the clipper or connect to AC outlet.
1. Turn the switch "OFF" and insert plug for equipment into the unit socket. (Fig.2)
Charging can only be done at the "OFF" position.
2. Insert power plug into outlet. (Fig.3)
During charging, the charge indicator lamp lights.
Standard charging time is 5 hours.
The unit can be operated for about 50 minutes on a full charge.
When using continuously for more than 20 minutes, stop and allow to rest about 10 minutes every
20 minutes and lubricate oil to the cutting edge.
Continuous use of the unit for over 20 minutes may cause deterioration of cutting performance.
This is the same with when using the unit with AC current.
3. After charging the clipper, unplug the power adaptor and plug for equipment.
Do not pull on cord when removing power plug for equipment. （Fig.4)
Do not charge the clipper if room temperature exceeds 40 ℃ or drops below 5℃.
Extreme temperatures will shorten battery life.
DIRECT AC POWER SOURCE
As in the case of charging, insert plug for equipment into the socket and power plug into outlet.
Wait 2 minutes to turn the switch on.
If the switch is set at "OFF" after use, the clipper starts charging.
BEFORE USING
1. Open the cutter in direction of arrow. (Fig.5)
2. Apply about 1 drop of accessory oil at the blade 4 oil points. (Fig.6)
Always lubricate before and after use.
Cutting performance deteriorates if the cutter is not lubricated properly. When doing more than one
haircut in one session, clean and lubricate the blade once after finishing each cut.
3. Close the cutter in direction of arrow. (Fig.7)
4. Allow the clipper to operate without actually cutting for about 10 seconds and wipe off any excessive
lubrication oil.
HEAD TILTING
Head can tilt 25 degrees as shown in the figure. (Fig.8)
Over 25 degrees
25°
CUTTING AND THINNING OPERATION
CUTTING
Slide the switch in direction of arrow ; and set the position read as "CUT" then the clipper starts
operating. (Fig.9)
Switch
Body
Cutter
Power adaptor (KH-185B)
Power plug
Opposite direction
-3-
Cord
Plug for equipment
Cleaning brush
Lubrication oil
Socket
Advertisement
