Download Print this page

Hitachi CL-8330BF Instructions Manual page 9

Advertisement

THINNING CUT
Slide switch in direction of arrow ; and set the position read as " I " then the thinning plate protrudes
and the blade starts operating. (Fig.10)
If the switch is pushed one step further in arrow direction, and set the position read " I I " and
the thinning plate protrudes clipper farther. (Fig.11)
HOW TO USE THINNING
When first starting to use the unit
When thinning a small quantity
When finishing
When thinning a large quantity.
CONNECTION AND ADJUSTMENT OF ATTACHMENT
1. While pressing knob at each side of the attachment, align attachment with cutting
height display panel (12 mm.... 3 mm) on the clipper and press the attachment as behind as
possible. (Fig.12)
2. Push attachment with finger to set for the desired height as shown in the figure. (Fig.13)
PREPARATIONS BEFORE CUTTING
1. Place a vinyl sheet or a sheet of newspaper on the floor.
Use a chair as high as possible for haircut work.
2. Apply powder to the neck, place tissue paper, and wrap around it with a towel. (Fig.14)
3. Put on a cape from the front and fasten it with a string.
If a suitable cape is not available, substitute a nylon wrapping cloth or the like.
NAMES OF HAIR PARTS (Fig.15)
Bangs
Crown
HAIRCUT
SHORT HAIR
1.Thinning (entire head)
(1) Comb hair to desired style.
(2) Lightly move the clipper from top to bottom as if combing the hair. (Fig.17.18)
Side
Front
By keeping one hand underneath the hair while cutting with the clipper, there is little chance of cut
hair getting in the face.
Do not thin hair near top of head since short hair will stand up.
2.Cutting top head
Pull up hair between fingers directly perpendicular to top head and slowly run the clipper above
fingers to cut.
To ensure cutting at the same length, take up hair already cut together with hair to be cut and
cut latter to the same length as the former. (Fig.19.20)
3.Cutting around ears
Put the cutter lightly against the skin and move it in a circle in the arrow direction. (Fig.21.22)
Hold the ear by hand to facilitate the job.
4.Side cutting (evening up the sides)
Put the cutter at right angles to the skin to trim the hair. (Fig.23.24)
5.Shaving downy hair
Put the cutter directly on the skin and shave the downy hair working from the lower to the upper
part of the neck. (Fig.25.26)
Do not press the cutter too hard.
6.Finishing the whole head
Comb entire head. Even out any rough parts by using the clipper with thinning comb. (Fig.27.28)
Thinning plate
Cutting height display
Around ears
Sideburn
Back
-4-
Thinning (light) " I I "
Thinning (heavy) " I "
Neck
Neck
Sideburns

Advertisement

loading