• The IPLink 2603/2620 contains no user serviceable parts. The equip- ment shall be returned to Patton Electronics for repairs, or repaired by qualified service personnel. WARNING • An approved external power supply that incorporates a disconnect device shall be used and positioned within easy reach of the operator.
9600 bps, 8 data bits, 1 stop bit, no parity, no flow control Log in to the IPLink using the factory-default login and password: superuser Login: Password: superuser Login successful IPLink 2603 & 2620 Quick Start Guide figure t e w i n k o l e Figure 1.
The Model 2620 does not have an MDI-X switch, so you must use a cable wired straight-through to con- nect the Model 2620’s Ethernet port to the IP network. If you have a Model 2603, press the MDI-X switch until the Ethernet Link LED turns on. Figure 2.
Page 5
75-ohm E1 lines. To connect the WAN port on a Model 2620 or Model 2603/T, or if you plan to use the RJ-48C port on a 2603/K, refer to section “Connecting to the RJ-48C WAN port”. Otherwise, refer to section “Connecting to the unbalanced 75-ohm TX and RX WAN ports (Model 2603/K and 2620/KK only)”...
To finish configuring your IPLink, and for detailed information about installing, configuring, operating, and trou- bleshooting, refer to the Models 2603, 2621, and 2635 IPLink Series High Speed Routers User Guide and appli- cation notes, available on the enclosed Patton CD-ROM or at A.0 Customer and Technical Support...
If trouble is experienced with this equipment, for repair or warranty information, please contact our company. If the equipment is causing harm to the telephone network, the telephone company may request that you discon- nect the equipment until the problem is resolved. IPLink 2603 & 2620 Quick Start Guide...
Warranty, Trademark, & Compliance Information For warranty, trademark and compliance information, refer to the Models 2603, 2621, and 2635 IPLink Series High Speed Routers User Guide located on the CD-ROM that came with your router or available online at www.patton.com.