Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Shimano PD-MX80
Summary of Contents for Shimano PD-MX80
- Page 1 (English) DM-PD0001-01 Dealer's Manual PD-MX80...
-
Page 2: Important Notice
• Do not disassemble or modify the product other than as stated in the information contained in this dealer’s manual. • All dealer’s manuals and instruction manuals can be viewed on-line on our website (http://si.shimano.com). • Please observe the appropriate rules and regulations of the country, state or region in which you conduct your business as a dealer. -
Page 3: To Ensure Safety
• When installing components, be sure to follow the instructions that are given in the instruction manuals. It is recommended that you use only genuine Shimano parts. If parts such as bolts and nuts become loose or damaged, the bicycle may suddenly fall over, which may cause serious injury. - Page 4 Tool The following tools are needed to assemble this product. Usage location Tool Crank 15 mm spanner Adjust pin #T15 TORX® * TORX is a registered trademark of Acument Intellectual Properties, LLC.
-
Page 5: Installation
INSTALLATION „ Mounting the pedals on the crank arms Apply a small amount of grease to the thread to prevent sticking. Use a 15 mm spanner to mount the pedals on the crank arms. • The right pedal has a right-hand thread; the left pedal has a left-hand thread. Remove any roughness or burrs on the joint, if detected. - Page 6 ADJUSTMENT „ Adjusting the gripping force Remove spacers or add pins to adjust the gripping force between the shoes and the pedals. • On this pedal, there are 18 pin mounting locations on top and bottom in total. The pedal is shipped with the setup as shown below.
-
Page 7: Maintenance
MAINTENANCE „ Pin If the pins become worn or damaged, replace them with new pins. #T15 TORX® Tightening torque: 2 - 2.5 N·m {18 - 21 in. lbs.}... - Page 8 „ Axle unit Adjustment is required if the rotating parts are not functioning properly. Follow the procedure shown below. Using a 20 mm wrench, loosen the lock bush to pull out the axle unit. • The right pedal has a left-hand thread; the left pedal has a right-hand thread. Use TL-PD63 or TL-PD33 special tool, or 7 mm or 10 mm open wrench to turn the cone (10 mm) to adjust the rotation.
- Page 9 „ Replacing and mounting the reflectors A special reflector set SM-PD64 is available. Mount reflectors with pins. Reflector Tightening torque: 2 - 2.5 N·m {18 - 21 in. lbs.} Note: • When using the product without a reflector, adjust the protrusion of pins using attached spacers. For details, refer to “Adjusting the gripping force”.
- Page 10 Please note: specifications are subject to change for improvement without notice. (English) © Nov. 2013 by Shimano Inc. HTR...
Need help?
Do you have a question about the PD-MX80 and is the answer not in the manual?
Questions and answers