Advertisement
Note: This step is done when frame is in the skin.
For illustration purposes, we have shown it without the skin.
A
B
1 3
I N S TALLING LARGE CROSSRIBS.
•
Position large crossrib to lay on top of gunwale tubes.
Slide forward towards pins on gunwale tubes. Rotate
crossrib into position.
•
Place crossrib between gunwale pins nearest you by push-
ing gunwale bar up over end of crosspiece and snapping
into position.
FOR BOW CROSSRIB:
•
There are two black plastic blocks mounted on the keel
bar. One is mounted with a screw and can be rotated.
When rotated away from the other block, it is in the
"open" position. Have the block set in the "open" position.
•
Insert pin located on bottom of crossrib into stationery
black block on keel bar. Twist the second block into the
"closed" position. Snap crosspiece into position on
gunwales, then chines.
1 4
R E P E AT STEP 13 FOR INSTA L L ATION OF STERN CROSSRIB.
•
Procedure is the same, except for twister.
Delrin "twister"
Feat hercr aft
K-Light Plus
1 6
Hide quick links:
Advertisement
