Download Print this page

West Bend 65041 Instruction Manual page 4

Professional snowball machine

Advertisement

Available languages

Available languages

1. Slide the ice funnel into the shaving bowl, lining the tabs on the funnel with the
slots in the shaver bowl. Turn the funnel slightly clockwise to lock in place.
2. Place the drip tray into the opening in the shaver body. Slide the snow container
under the blades. Be sure that it is slid all the way to the back of the machine. If
you do not wish to use the snow container, place a wide bowl below the blades,
on the drip tray.
3. Add ice cubes to the ice funnel. Ice funnel can be filled to the top, but the cover
must be able to latch securely, remove ice if cover cannot be latched.
4. Press down on
click.
5. Plug the Ice Shaver into a 120 volt, AC electric outlet only. Press the "On/Off"
switch to "ON" to begin shaving.
6. When shaving is complete, press the "On/Off" switch to "OFF."
7. Unplug from power supply immediately after use. Note: There will always be a
small amount of ice remaining in the shaving bowl after shaving. Discard the
remaining ice.
CAUTION: Do not run ice shaver continuously for longer than 3 minutes as
overheating may occur. Allow motor to cool down before repeat usage.
 A small amount of smoke and/or odor may occur upon use due to the release of
manufacturing oils – this is normal.
 Some minor expansion/contraction sounds may occur during use – this is
normal.
 Be sure you have an adequate supply of ice cubes.
 Colder ice produces a more snow-like shaved ice. Ice that is allowed to thaw a
little will create a wetter, heavier shaved ice.
 DO NOT overfill the ice funnel; the cover should sit flush without forcing.
1. Always unplug appliance before cleaning.
2. Hand wash parts in warm, soapy water. Rinse and dry thoroughly. To remove
excess ice from the shaving bowl, remove the drip tray and tip the shaver over a
sink to dump out. CAUTION: Be extremely careful of blades in shaving bowl as
blades are very sharp.
3. Clean exterior of the appliance with a damp, soft cloth and wipe dry. Note: Do
not immerse motor housing in water or other liquid.
NEVER ATTEMPT TO SHARPEN BLADES AS INJURY MAY OCCUR.
English - 4
U
Y
SING
OUR
to close the lid on top of the shaving bowl. You will hear a
H
C
Y
LEANING
OUR
This appliance has no user serviceable parts.
S
B
NOW
ALL
H
ELPFUL
INTS
S
B
NOW
ALL
M
ACHINE
M
ACHINE

Advertisement

loading