Table of Contents
Advertisement
3
Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in sequence.
Install the car audio
These instructions are for a typical installation. However, if
your car has different requirements, make the corresponding
adjustment. If you have any questions regarding installation
kits, consult your Philips car audio dealer.
Caution
•
This unit is designed for negative ground (earth) 12 V
DC operation only.
•
Always install this unit in the car dashboard. Other
locations can be dangerous as the rear of the unit heats
up during use.
•
To avoid short-circuit: before you connect, ensure that
the ignition is off.
•
Ensure that you connect the yellow and red power
supply leads after all other leads are connected.
•
Ensure that all loose leads are insulated with electrical tape.
•
Ensure that the leads do not get caught under screws
or in moving parts (e.g. seat rail).
•
Ensure that all ground (earth) leads are connected to a
common ground (earth) point.
•
Use only the supplied mounting hardware for a safe
and secure installation.
•
Improper fuses can cause damage or fire. When you
need to change the fuse, consult a professional.
Note on the power supply lead (yellow)
•
When you connect other devices to this system, ensure
that the rating of the car circuit is higher than the total
fuse value of all the connected devices.
Notes on speaker connection
•
Never connect speaker wires to the metal body or
chassis of the car.
•
Never connect speaker wires with stripes to one another.
Connect wires
Caution
•
Ensure that all loose leads are insulated with electrical
tape.
1
Check the car's wiring carefully, then connect them to
the ISO wires.
Connector
Connect to
1
Yellow wire
The +12V car battery which is live at
all times.
2
Blue/White
The electric antenna control lead or
wire
power supply lead of the antenna
booster. If there is no electric antenna
or antenna booster, or it is manually
operated telescopic antenna, it is
unnecessary to connect this lead.
3
Black wire
A metal surface of the car. Connect
the black ground (earth) lead before
connect the yellow and red power
supply leads.
4
Red wire
The +12V power terminal which is live
in the accessory (ACC) position of the
ignition switch. If there is no accessory
position, connect to the +12V car
battery terminal that is always live.
Ensure that black ground (earth) lead
is connected to a metal surface of the
car first.
5
Green and
Left speaker (Rear)
green/black
wires
6
White and
Left speaker (Front)
white/black
wires
7
Gray and gray/
Right speaker (Front)
black wires
8
Purple and
Right speaker (Rear)
purple/black
wires
2
Connect the other end of the standard connector to
the car audio system.
EN
9
Advertisement
Table of Contents
