Full Mesh Forwarding Mode Configuration Example - HP H3C S9500 Configuration

Operation Manual – HA
H3C S9500 Series Routing Switches
[Sysname] slave switchover
Caution!!! Confirm switch slave to master[Y/N]?y
After the switchover, the original AMB will reset, restart, and update its application file.
Thus, the whole system has its application upgraded dynamically.

1.4.2 Full Mesh Forwarding Mode Configuration Example

I. Configuration prerequisites
Two SRPUs work in active and standby mode.
Set the Full Mesh forwarding to enhance mode to optimize the Full Mesh
forwarding performance in the system.
II. Configuration procedure
# Enter system view.
<Sysname> system-view
# Switch to load balancing mode.
[Sysname] xbar load-balance
# Enable Full Mesh mode.
[Sysname] fullmesh-enhance enable
# Check whether Full Mesh mode is activated.
[Sysname] display fullmesh-enhance
Configuration status: Enabled
Operation status: Active
1-4
Chapter 1 HA Configuration