Installation; Connecting The Twisted-Pair Line Interface - Patton electronics CopperLink 2155 User Manual

Because the CopperLink Ethernet Extender requires no configuration, it can
be installed quickly. Installation consists of the following:
• Connect the line interface between the units (refer to section 3.1,
"Connecting the Twisted-Pair Line Interface" on page 7)
Note See Figure 2 for the rear-panel connectors locations.
• Connect the Ethernet interface (refer to section 3.2, "Connecting
10Base-T Ethernet Port to PC (DTE)" on page 8 or section section 3.3,
"Connecting 10Base-T Ethernet Port to Hub (DCE)" on page 8).
• Connect the power plug (refer to section 3.4, "Connecting Power" on
page 9).
Interface connector
ON |
Power
OFF O
Power input
connector

3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE

The Model 2155 supports communication between two peer Ethernet
LAN sites over a distance greater than 5 miles (8 km) over 24 AWG (0.5
mm) twisted-pair wire.
Follow the steps below to connect the CopperLink interfaces.
Note Model 2155 units work in pairs. One of the units must be a
Model 2155/L (local) and the other unit must be a Model 2155/R
(remote).

3.0 INSTALLATION

Made in the USA
Interface DSL
P o M o
Figure 2. CopperLink Ethernet Extender rear panel
DSL interface
G . 7
w e d e l
0 3 /
r
1 1
G . 7
M a
9 4
0 4 5 1
d e
E S
T e s 1 E
i n i n
t
g l e M o t h e
d e
U S
M o
s
d e D S A
F i b
L
e r -
Q u
a d
G . 7
0 3 /
G . 7
0 4
I n t
e r
M o
f a c
d e
e
m
7