Peg-Perego pliko p3 Instructions For Use Manual page 19

29• The handy rain canopy can be lowered by opening the
zipper. It can be left mounted on the stroller with the
elastic bands.
30• This rain canopy has been designed also for strollers that
have the Primo Viaggio car seat mounted on them, to
guarantee total protection.
• Do not use the rain canopy indoors and always check to
be sure that your child is not too hot.
• Do not place the PVC rain canopy near sources of heat
and pay attention to cigarettes.
• Verify that the rain canopy cannot interfere with any
moving mechanism of the chassis or stroller.
• Always remove the rain canopy before closing your
chassis or stroller.
• Wash with a sponge and soapy water without using any
detergent.
BRAKE
31• To apply the brakes, push down with one foot the bars
on the rear wheels, as shown in the figure. To release the
brakes, draw the bar up. Always set the brakes on the
stroller when it is not in motion.
SAFETY BELT
32• A: Make sure that the brace is properly inserted by
pushing as shown in the figure. B: Fasten the belt as
shown in the figure.
33• To unfasten the belt, press on the buckle sides and pull
out the waist strap.
34• The new safety belt is now easier to fasten thanks to the
"snap-open-and-shut" device. Before fastening the safety
belt, attach the buckle to the backrest by inserting the
tab through the special holder, as shown in the figure.
After fastening the safety belt on your child, detach
it from the backrest to allow the child more freedom
of movement. The buckle must remain below the child's
shoulders.
ADJUSTING THE FOOTBOARD
35• The footboard can be adjusted to three different
positions. To lower the footboard, pull the two small levers
downward while lowering. To lift the footboard, pull it up
until it clicks into place.
ADJUSTING THE BACKREST
36• The backrest can be reclined in four positions. To lower
the backrest, raise the handle as you lower the backrest,
blocking it in the desired position. To raise it, push the
backrest upward.
SWIVELLING WHEELS
37• To make the front wheels swivel, push down as shown in
the figure. To fix the wheels, pull up the lever.
ADJUSTING THE HANDLES
38• The height of the handles can be adjusted in two
positions. For the upper position, press the button as you
raise the handle. To lower it, press the button as you lower
the handle.
FRONT BAR
39• The front bar can be opened on one side only to make it
easier for the child to get into the stroller when he is older.
To open the bar, press the button under the armrest while
pulling the bar outwards.
40• To remove the front bar, press the two buttons under the
armrests while pulling the bar outwards.
REAR LEDGE
41• The rear ledge helps overcome small rises and can also be
used to carry a second child.
LOADING SEQUENCE
42• To use the stroller with two children, brake the stroller,
place the smaller child in the seat and fasten the safety
belt (1). Grip the handles (2) and help the second child
climb onto the footrest (3). Never leave your children
unattended. Do not allow the child to climb onto the
rear footrest when the stroller is empty.
CLOSING
Before closing the stroller, loosen the braces if
the hood is attached, and raise the backrest if it is
lowered.
43• The stroller can be closed with one hand: pull first one
lever up and then the other until it releases.
44• Grip the central handle and pull it upward until it closes,
as shown in the figure.
45• Verify the correct closing of the stroller from the safety
hook. The folded stroller can stand upright.
TRANSPORT
46• The stroller can easily be carried (lock the swivelling front
wheels) by gripping the central handle, as shown in the
figure.
47• You can also use the side handle to carry it, as shown in
the figure.
REMOVABLE LINING
48• To remove the stroller's lining, loosen the fasteners on the
armrests as shown by the arrows.
49• Unbutton the sack at the side, as shown in the figure. Slip
the leg divider on the safety belt out from under the seat.
50• Unscrew the strap (only on one side) as shown in the
figure, holding your finger under the nut.
51• Unbutton the sack from the seat, and slip it off the hooks
on the footboard.
52• Slip the sack off the side of the backrest, as shown in the
figure.
53• Slip the previously loosened strap through the slit in the
sack, as shown in the figure.
54• Remove the sack and wash it, following the instructions
given here.
• To remount the sack on the stroller, carry out the
instructions in the reverse order, making sure to screw the
strap back into place.
ganciomatic system
The Ganciomatic System is the swift, practical system
that allows one to fasten the following products, which
can be bought separately and are also equipped with
Ganciomatic System, to the stroller, thanks to Ganciomatic
fasteners.
• Primo Viaggio: the Group 0+ (weight from 0 to 13 kg) car
seat is fastened in cars with the vehicle's safety belt.
• Navetta: the comfortable bassinet unit becomes a
carriage when attached to the fasteners of the stroller.
Equipped with a foldable hood and carrying handle, both
the air circulation regulation system inside the bassinet
and the inclination of the backrest are adjustable from
outside. It can also be used at home as a small cradle,
thanks to the feet, or as a rocker.
STROLLER GANCIOMATIC HOOKS
55• To raise the Ganciomatic hooks on the stroller, pull the
sack up at the corners of the seat and turn the two hooks
upwards until they click into place.
56• To lower the Ganciomatic hooks on the stroller, pull the
little lever outwards and turn the hooks upwards at the
same time, as shown in the figure.
PLIKO P3 + PRIMO VIAGGIO CAR SEAT
57• To fasten the car seat to the stroller:
- set the brake on the stroller;
- remove the hood from the stroller;
- completely lower the backrest on the stroller;
- raise the Ganciomatic hooks on the stroller;
- place the car seat, turned towards the adult, on the stroller