Waking Up The System - Cisco TelePresence Profile Series User Manual

Cisco TelePresence System Profile-series, C-series codecs, Quick Set C20
Contents Getting started Getting started

Waking up the system

To make a call you need to wake up the system from standby. However, if someone calls
you, the system will wake up by itself.
• To wake up the system just pick up the TRCV remote control or press any key. You
may have to point the remote control towards the system to make sure it discovers
you.
• The system will now display the wallpaper.
• The dial-in address (H.323 Alias ID) or dial-in number (H.323 Alias E164) of your
system is displayed in the upper left corner. If you have questions about the dial-in
address or number, contact your system administrator.
• The screen will also indicate if there are any calls you have missed.
D14582.04 User guide Cisco TelePresence Profile, C-series codecs, Quick Set C20, Nov. 2010.
All contents are Copyright © 2010 Cisco Systems, Inc. All rights reserved.
Making calls Phone book usage
4
In-call features
After wake-up, the screen will typically look like this:
The dial-in address (H.323 Alias ID) or dial-in number
(H.323 Alias E164) of your system is displayed in the
upper left corner.
norah.dollhouse@somecompany.com
Softkeys (described on the following pages).
.
If the system fails to respond to the remote control or to incoming calls, make sure that:
• The system is connected to line voltage.
• The remote control has working batteries.
• The internal cables, such as the monitor cable and/or the camera cables are properly
connected, see the installation sheet for details, if needed.
User guide
Advanced settings Contact us
Date and time of day.
Sept
20
www.cisco.com