Download Print this page

Advanced System Functions - Firstech 2W902R-SP User Manual

2 way 5 button led remote
Hide thumbs Also See for 2W902R-SP:

Advertisement

General System Functions
Your remote comes with an automatic button lock feature. This feature automatically locks all four buttons on your remote after one minute. To unlock just
tap any button then tap or hold the button(s) for the command you would like to send. This feature must be turned on in the Remote Option Menu.
STEP 1: Enter remote programming mode by holding the Trunk and Key/Start buttons
3 times and the LEDs will flash purple on your remote indicating that you have successfully entered programming mode.
STEP 2 : Tap the Start
button. One chirp and LED flash indicates that Automatic Button Lock is on. Tap the Start
Button Lock off. Two chirps and LED flashes indicates the feature is off.
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons
indicating that you have successfully exited programming.
By Firstech, LLC
20

Advanced System Functions

simultaneously for 2.5 seconds. The remote will beep
button again to turn Auto
simultaneously for 2.5 seconds. The remote will beep
The following section reviews advanced system functions. Many of these functions require multiple steps or additional programming by your local
authorized Firstech dealer to be active.
Tap the Function button
once followed by the Lock button
remote will beep once and the LED flash once to confirm that drive lock mode is activated. The remote will beep twice and LED flash twice to to confirm
drive lock is off.
IMPORTANT: Drive lock mode requires that the dealer turn on Option 1-9. Drive lock has two settings;
Default 1: Off
Option 2: Locks the doors when the ignition is on and after the brake is depressed.
Option 3: locks the doors when the RPM's have reached two times that of idle speed (this setting requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual transmission vehicle, the doors will unlock
upon setting the emergency / parking brake.
The built in turbo timer keeps the vehicle's engine running for either 1, 2, or 4 minutes (programmable from dealer) after the vehicle key has been removed
from the ignition. This feature will keep oil running through the turbo system to allow for appropriate cooling time.
Tap the Function button
once followed by the Unlock button
confirm that turbo mode is activated. Repeat to turn turbo timer off. The remote will beep twice and LED flash twice to confirm turbo mode is off.
IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the Firstech system. Consult your local authorized dealer
for installation.
to turn the Drive Lock on and off. (also known as ignition controlled door locks) The
to turn turbo mode on or off. The remote will beep once and LED flash once to
21
By Firstech, LLC

Hide quick links:

Advertisement

loading