KVH Industries TracVision M7 Installation Manual page 21

15 Select Satellites
Follow these steps and refer to the flowchart in
Figure 36 to set up the system for Bell TV
(formerly ExpressVu). The antenna will track Bell
TV's 91 and 82 satellites.
a. At "Set up satellite(s)," press the YES button
on the MCP's front panel.
b. At "Circular or Linear?," press CIR.
c. At "Service=DIRECTV," press NEXT until
the display shows "Service=ExpressVu."
Then press YES.
d. At "Set Sat Switch Type," press AUTO for
automatic satellite switching or MANUAL
for manual switching. Manual switching is
only required if a multiswitch is installed.
e. At "Set Lat/Long?," press YES.
TIP: You can determine your approximate latitude
and longitude in North America from the position
grids provided in Appendix C on page 31.
f. At "Latitude," use the - and + buttons to set
each digit of the vessel's latitude. Press Enter
to accept each digit.
g. At "Longitude," set the vessel's longitude.
Circular Systems - Bell TV
Figure 36: Bell TV Satellite Selection Menus on MCP
Set up satellite(s)?
Yes
Circular or Linear?
Cir Lin Cancel
Service=DIRECTV?
Yes Next Cancel
Service=ExpressVu?
Yes Next Cancel
Set Sat Switch Type
Auto Manual Cancel
Set Lat/Long?
Yes Next Cancel
Latitude:
- Enter
Longitude:
- Enter
Latitude:
Longitude:
Installing EXVU sats
91 and 82
Restarting antenna
No
Press NEXT until
"Service=ExpressVu"
displays; then press YES
Use +/- to set
##N
vessel latitude
+
Use +/- to set
###E
vessel longitude
+
##N
###E
21