Install Mounting Bracket; Mounting The Camera - SimPal G4 User Manual

available again, the notification will be sent to the user, i.e." The device is now
resuming the use of external power source."
Low battery: The configure setting can not be saved when SimPal camera is

operating on low battery.

2.3 Install mounting bracket

The camera has a bottom bracket by which it can stand on the table.


2.4 Mounting the camera

SimPal camera can be mounted on a wall (vertically with the screws) or put down on
any suitable horizontal surface.
How to choose the Installing place:
In order to capture better image quality, avoid any areas where bright light will

be irradiated directly into the lens of the camera on the camera.
In order to avoid backlighting photography, it is suggested that the camera is

located at the place where can look down the monitoring place with the
minimum angel 30°.
 The GSM network's signal strength may affect the image, live voice quality
and images transmission speed. Therefore, upon installation, the user should
ensure that SimPal camera is located in an area with a strong network signal.
 After installation, the user should perform a test-run by taking several images
and sending it to the user's mobile phone. This allows the user to check the
image quality of the camera. The position of SimPal camera can then be
adjusted until a satisfactory image quality level is reached.
11
SimPal-G4 3G Security Camera User Manual
www.microdata.fi support@microdata.fi 09 - 42474920