Cleaning The Water Intake Filters; Draining Remaining Water And Cleaning The Pump Filter - Beko WMY 71023 LMB3 User Manual

5.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of each
water intake hose where they are connected to the
tap. These filters prevent foreign substances and dirt
in the water to enter the washing machine. Filters
should be cleaned as they do get dirty.
1 Close the taps.
2 Remove the nuts of the water intake hoses to
access the filters on the water intake valves. Clean
them with an appropriate brush. If the filters are too
dirty, take them out by means of pliers and clean
them.
3 Take out the filters on the flat ends of the water
intake hoses together with the gaskets and clean
thoroughly under running water.
4 Replace the gaskets and filters carefully in their
places and tighten the hose nuts by hand.
5.5 Draining remaining water and cleaning
the pump filter
The filter system in your machine prevents solid items
such as buttons, coins and fabric fibers clogging the
pump impeller during discharge of washing water.
Thus, the water will be discharged without any
problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is
clogged. Filter must be cleaned whenever it is clogged
or in every 3 months. Water must be drained off first to
clean the pump filter.
In addition, prior to transporting the machine (e.g.,
when moving to another house) and in case of freezing
of the water, water may have to be drained completely.
A
WARNING:
Foreign substances left in the pump
filter may damage your machine or may cause
noise problem.
WARNING:
If the product is not in use, turn the
tap off, detach the supply hose and drain the
water inside the machine against any freezing
possibility in the region of installation.
WARNING:
After each use close the supply hose
tap of the product.
17 / EN
In order to clean the dirty filter and discharge the
water:
1 Unplug the machine to cut off the supply power.
A
WARNING:
Temperature of the water inside the
machine may rise up to 90 ºC. To avoid burning
risk, clean the filter after the water in the machine
cools down.
2 Open the filter cap.
3 Some of our products have emergency draining
hose and some does not have. Follow the steps
below to discharge the water.
Discharging the water when the product has an
emergency draining hose:
a Pull the emergency draining hose out from its seat
b Place a large container at the end of the hose. Drain
the water into the container by pulling out the
plug at the end of the hose. When the container
is full, block the inlet of the hose by replacing the
plug. After the container is emptied, repeat the
above procedure to drain the water in the machine
completely.
c When draining of water is finished, close the end by
the plug again and fix the hose in its place.
d Turn the pump filter to take it out.
Washing Machine / User's Manual