Performax 241-0968 Owner's Manual page 17

ADJUSTING THE FREEHAND CUTTING
GUIDE – cont'd
Before starting to cut, double check the bit
depth. Make sure the cutting guide is at a
right angle to the bit and securely
tightened. Double check the collet to make
sure the bit is securely fastened.
!
WARNING
For safety reasons, the operator
must read the sections of this
Owner's Manual entitled "GENERAL
SAFETY WARNINGS", "POWER
TOOL SAFETY", "SPECIFIC SAFETY
RULES", "EXTENSION CORD
SAFETY" and "SYMBOLS" before
using this cut-out saw.
Verify the following every time the
cut-out saw is used:
1. The cord is not damaged.
2. The bit is securely fastened in
the collet.
3. The bit is sharp and in good
condition.
4. Safety glasses, hearing
protection and dust mask are
being worn.
Failure to adhere to these safety
rules can greatly increase the
chances of serious injury.
ASSEMBLY AND OPERATING
17