Installing The Freehand Cutting Guide; Installing Cutting Bits - Performax 241-0968 Owner's Manual

INSTALLING THE FREEHAND CUTTING
GUIDE
The freehand cutting guide is designed for
basic freehand cutting with the cutting bit.
It is ideally suited for cutting electrical
outlet holes in drywall.
!
WARNING:
freehand cutting guide with router bits.
The amount of control this accessory
provides is insufficient and could cause
you to lose control and cause serious
injury.
1. Open the freehand cutting guide
mounting collar (1) by pulling the quick
release lever (2) outward (Fig. 2).
2. Slide the mounting collar onto the
bottom of the motor housing (3).
NOTES:
a) The mounting collar must be pushed
onto the motor housing as far as it will
go.
b) Rotate the mounting collar to position
it to provide the best visibility to the
bit.
3. Lock the freehand cutting guide onto
the motor housing by pushing the
quick release lever inward toward the
mounting collar until it snaps into the
locked position.

INSTALLING CUTTING BITS

!
WARNING:
bit cutting surfaces are extremely
sharp. Handle with caution.
To loosen and tighten the collet use the
collet wrench supplied with the tool.
ASSEMBLY AND OPERATING
Do NOT use the
Cutting bit and router
13
Fig. 2