Grizzly G0449 Owner's Manual page 53

15. Remove the control panel and set it to the
side without disconnecting any wiring.
16. Loosen the strain relief on the conveyor
motor cord, and disconnect wiring inside the
conveyor motor junction box.
17. Remove the conveyor feed motor. The sand-
er should now be disassembled as shown in
Figure 74.
Figure 74. Drum sander disassembled
to Step 16.
18. Using four strong people (or a forklift w/
straps), carefully lift the table off of the drum
sander cabinet, as shown in Figure 75.
Note: When removing the table, be careful
with the ball thrust bearings located under
the table elevation shafts (part #378 in the
breakdown drawing), as they can be easily
knocked onto the ground.
Figure 75. Lifting the table off of the drum
sander cabinet with four people.
Model G0449/G0450 (Mfd. Since 8/13)
19. Remove the brackets from the left side of the
table and remove the belt (see Figure 76).
Note: Leave the front pillow bearing connect-
ed to the bracket, but disconnect that bracket
from the table.
Figure 76. Conveyor belt removed from table.
20. Install the new belt and reassemble the drum
sander by reversing the disassembly steps.
21. After reassembly, adjust the drums and pres-
sure rollers to their proper settings. See Drum
Adjustments on Page 41 and Pressure
Roller Height on Page 46.
-51-