Control Panel - Vita-Mix 7500 Owner's Manual

7500, Pro-300 and Creations Elite Models
On/Off Switch:
1.
The On/Off (or Power) Switch is on the right-hand side of the machine base. The On/Off Switch controls the power to the machine.
BEFORE moving the On/Off Switch to the On (I) position, make sure the Start/Stop Switch is in the Stop ( ) position and the
Variable Speed Dial is to the far left, pointed at number 1. Move the On/Off Switch to the Off position whenever the machine will
be left unattended.
On/Off Indication:
2.
When the Pulse ( ) and Start ( ) symbols brighten, the machine is plugged in, the On/Off Switch is powered On and power is
flowing.
Start ( )/Stop ( ) Switch:
3.
Before blending, make sure that the Variable Speed Dial is pointed at 1. Lifting the Start/Stop Switch to the Start Position ( )
initiates the rotation of the blades and begins the blending process. Pressing down on the Start/Stop Switch to the Stop Position ( )
will stop the blending process.
Variable Speed Dial:
4.
The Variable Speed Dial selects blade rotation speeds from 1 to 10 (low to high). Always begin the blending process with the
Variable Speed Dial set to 1. Make sure that the On/Off Switch is in the On (I) position. Move the Start/Stop Switch to the
Start ( ) position. Rotate the Variable Speed Dial to the desired speed setting. To stop the machine, rotate the Variable Speed Dial
back to 1 and move the Start/Stop Switch back to the Stop ( ) position. If the Variable Speed function is not working and the blades
only rotate at the lowest speed (Variable Speed 1) the blender must be reset. Refer to Troubleshooting.
Pulse Switch ( ):
5.
Pressing down on the Pulse Switch will cause the machine to blend at the speed setting shown on the Variable Speed Dial for as
long as the Pulse Switch is held down.
CO N T R O L PA N E L
2
5
4
3
1
5