Adjusting Brake Pedal; Every 200 Hours; Replacing Engine Oil Filter - Kubota B2301 Operator's Manual

Hide thumbs Also See for B2301:
Table of Contents

Advertisement

60
PERIODIC SERVICE
BAdjusting Brake Pedal
To avoid personal injury or death:
A Stop the engine and chock the wheels before
checking brake pedal.
30 to 40 mm on the pedal
Proper brake pedal
Keep the free travel in the right
free travel
and left brake pedals equal.
1. Release the parking brake.
2. Slightly depress the brake pedals and measure free
travel at the top of pedal stroke.
3. If adjustment is needed, loosen the lock nut and turn
the turnbuckle to adjust the rod length within
acceptable limits.
4. Retighten the lock nut.
(1) Lock nut (Both sides)
(2) Turnbuckle (Both sides)
(A) Free travel

EVERY 200 HOURS

BReplacing Engine Oil Filter
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
(1) Engine oil filter
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

B2601

Table of Contents