Rs-232C Command Table - Sharp PN-R556 Operation Manual

Controlling the Monitor with a PC (RS-232C)

RS-232C command table

How to read the command table
Command: Command field (See page 34.)
Direction: W When the "Parameter" is set in the parameter field (see page 34), the command functions as described
R The returned value indicated under "Reply" can be obtained by setting "????", "
Parameter: Parameter field (See page 34.)
Reply: Response (Returned value)
* : "●" indicates a command which can be used in power standby mode regardless of the POWER SAVE MODE
"○" indicates a command which cannot be used in power standby mode when POWER SAVE MODE is set to ON.
"–" indicates a command which cannot be used in power standby mode regardless of the POWER SAVE MODE
Power control/Input mode selection
Function
POWER CONTROL
INPUT MODE SELECTION
38
E
under "Control/Response Contents".
(repeater control) in the parameter field. (See page 34.)
setting.
setting.
Command Direction
POWR W
R
INPS W
R
Parameter Reply
0 Switches to standby mode.
1 Returns from standby mode.
0 Standby mode
1 Normal mode
2 Input signal waiting mode
0 Toggle change for input mode. Terminals not selected in INPUT SELECT
cannot be selected.
1 DVI-D
2 D-SUB[RGB]
"ERR" when other than RGB is selected for D-SUB of INPUT SELECT.
3 D-SUB[COMPONENT]
"ERR" when other than COMPONENT is selected for D-SUB of INPUT
SELECT.
10 HDMI1
13 HDMI2
14 DisplayPort
21 OPTION
"ERR" when nothing is attached in the expansion slot.
1 DVI-D
2 D-SUB[RGB]
3 D-SUB[COMPONENT]
10 HDMI1
13 HDMI2
14 DisplayPort
21 OPTION
?" or "???+"
Control/Response contents *
●