Adjustments For Pc Screen Display - Sharp PN-R556 Operation Manual

Menu Items
nAbout remote control numbers
If there is the chance that you will operate the wrong set from
the remote control, you can prevent this from happening by
changing the remote control numbers to different values in
advance. You have to make changes on the monitor and on
the remote control.
TIPS
• You can set remote control numbers to values from 0 to 9.
• When the remote control batteries become exhausted and
when you replace the batteries, the number on the remote
control may be reset to 0.
Changing the remote control number on the monitor
Use REMOTE No. on the SETUP menu to set the number.
(See page 26.)
1. Use to select the remote control number.
2. Select ON and press ENTER button.
The remote control number is set on the monitor.
Changing the remote control number on the remote
control
1. While holding down the ID SET button, hold down the
number that corresponds to the remote control number
set on the monitor for 5 seconds or more, and then
release these buttons.
The remote control number is set on the remote control.
Checking the remote controller number
1. Press INFORMATION button to display INFORMATION1.
2. Check that REMOTE No. is the remote control number
that you have set in the above procedure.
3. Press RETURN button to close the monitor information
screen.
TIPS
• If the remote control numbers on the monitor and remote
control are different, they will both be displayed on
INFORMATION1. On this screen, you can press ENTER
button to match the number on the monitor with the number
on the remote control. Even if the remote control numbers
are different, you can use the remote control to display the
INFORMATION screen.
32
E

Adjustments for PC screen display

nAutomatic adjustment
When you use the D-SUB[RGB] to display a PC screen for the
first time, or when you change the setting of the PC, use the
automatic screen adjustment.
1. Switch the input to D-SUB[RGB] and display the
adjustment pattern. (See the description below.)
2. Press MENU button and use
SCREEN menu.
3. Press ENTER button and select "AUTO".
4. Press ENTER button.
The automatic adjustment is complete in several seconds.
5. Press MENU button to close the menu screen.
TIPS
• If the screen cannot be adjusted properly with one
automatic adjustment, repeat the automatic adjustment two
or three times. Try manual adjustment if necessary.
nScreen display for adjustment
Before making adjustments in the SCREEN menu or
PICTURE menu, display an image to brighten the entire
screen. If you are using a Windows PC, use the adjustment
pattern on the supplied CD-ROM.
Opening the adjustment pattern
The following example is performed in Windows 7.
1. Load the supplied CD-ROM into the computer's CD-
ROM drive.
2. Open [CD Drive] in [Computer].
3. Double-click [Adj_uty.exe].
The adjustment pattern will appear.
Adjust the screen automatically or manually.
4. When adjustment is finished, press the [Esc] on the
computer's keyboard to quit the adjustment program.
5. Eject the CD-ROM from the CD-ROM drive.
TIPS
• If the display mode on the computer you are using is
65,000 colors, the color levels in the color pattern may
appear differently or grayscale may appear to be colored.
(This is due to the specifications of the input signal and is
not a malfunction.)
or to display the