BHM Medical Voyager V5 Duo Technical Manual page 33

Maintenance and Service
Removing the limit switch:
1
Select the two high limit wires from the main circuit harness (both are blue) and with
a extractor tool, disconnect them from main circuit connector.
2
Remove the strap inlet.
3
Remove the lateral (left/right) motor.
4
Remove the limit switch plate, and then the limit switch.
Remove screws
with a Torx T20
screwdriver
Remove screw with
with 8 mm wrench
Fig. 28
33
High Limit Switch Replacement
Main Circuit Harness Wiring
1) Red/white - From switch
2) Not used
3) Blue - Lateral motor
4) Blue - High limit switch
5) Not used
6) Red - Lateral motor
7) Not used
8) Blue - High limit switch
9) Black/white - Battery
10) Orange - From switch
11) Red - Vertical motor
12) Blue - Vertical motor
Remove nuts with
5 mm socket